V3SOUND Yammex Manual - page 3
2
The V3 unit can be connected to any USB Audio
Class 1 compatible keyboard. The V3 unit can
supply your USB keyboard with a maximum of
500mA. If your keyboard requires more than
500mA, you will need an external power supply.
The polarity of the sustain foot pedal is set up au-
tomatically when you turn on the V3. The pedal
only works on MIDI channel 1.
MIDI-THRU
MIDI-IN
PO
WER ON/OFF
USB-HOST
PED
AL
MAIN REVERB
LED - POWER ON
LED - MIDI
MAIN VOLUME
PROGRAM LIST SOLO SOUNDS
USER INTERFACE PORTS
CONNECT - USB
FOOT PEDAL
!
To avoid possible damage to the loud speakers or
other connected electronic devices, always con-
nect all cables before turning on the units.
Plug the power adapter that came with the
YAMMEX into the DC port on the back of the unit.
Plug the other end of the power adapter into a
power outlet.
Connect the MIDI-cable
MIDI-OUT
Keyboard (MIDI OUT A)
MIDI-IN
YAMMEX
You can also use a USB cable in place of the
MIDI cable.
Connect the audio outputs
OUT L & R
YAMMEX
AUX-IN
Keyboard
You can also connect the YAMMEX AUDIO-OUT
to a mixer and adjust the volume there.
Move up the V3 YEMMEX
MAIN VOLUME potentiometer to
maximum.
Turn on YAMMEX first,
then power on the keyboard.
NO SOUND - No MIDI-LED
The YAMMEX MIDI LED only lights up when you
have correctly selected a sound. To do this, you
must send the following messages over MIDI:
MSB Bank 63
LSB Bank 80 (80 is just an example)
Prg. change 1
This will only be done automatically if you have
correctly installed the voices using the YAMAHA
YEM Editor. If this does not happen, check the
bank setting as described on page 3.
MIDI-IN
MIDI-OUT
A - KEYBO
ARD
A
UX-IN KEYBO
ARD
OR MIXER
PO
WER ON/OFF
USB-HOST
PROGRAM LIST SOLO SOUNDS
CONNECT AND POWER UP