V3SOUND Yammex Manual - page 4
3
To select Yammex Sounds from your keyboard, you must first upload the data to your keyboard. The
data files are located here:
www.v3sound.com/en/e-support-yammex.html
How to install voices with the YEM Editor Version 1.51:
1. Click on „My Packs“
2. Then click on the “+” symbol
3. Select IMPORT PACK
4. Select the pack with the lowest
number (Bank 80).
5. Install the LSB bank for this pack.
Click the symbol „>“ under My Pack
and select Change Bank Select LSB
(the name of the pack is the LSB number).
NOTE: You must manually set the LSB bank number for each sound bank.
After you have loaded all the banks,
set the correct call-up for the VOICES
on the keyboard from the LSB BANK
as shown here.
Now you can end your installation
as instructed in the YEM Editor manual.
Press Install Target ...
PROGRAM LIST SOLO SOUNDS
INSTALL VOICES
GENOS / T5 / PSR-S975-970-775-770
V3SOUND
An installation with the EXPANSION Manager is NOT absolutely necessary - see left side.
So that you can select the Yammex sounds on the display of your keyboard, simply copy the USER
VOICE data that we provide on our homepage for free to your keyboard.
www.v3sound.com/de/d-support-yammex.html
The USER VOICE data has been tested on the following models:
GENOS
TYROS 2 - 3 - 4 - 5
PSRS975-970-775-770-670-675
An additional installation with EXPANSION MANAGER is NOT absolutely necessary.
You just have to make sure that you do not assign the LSB banks 80-96 to other PACKS.
However, an additional installation of the VOICES with the EXPANSION MANAGER is possible.
In addition, you can still select the YAMMEX Voices as PRESETS in the EXPANSION Packs.
PROGRAM LIST SOLO SOUNDS
PROGRAM LIST SOLO SOUNDS
INSTALL VOICES
GENOS / T2-3-4-5 /PSR-S975-970-775-770
INFORMATION FOR EXPANSION MANAGER