V7 EGS16 User Manual - Table of C

Summary of EGS16

  • Page 1

    User manu al egs16 egs24 pegs8 pegs16.

  • Page 2: Table of C

    I table of c ontent s 1 introduction package contents main features front panel rear panel 2 safety instructions preparation before installation personal safety caution 3 installation desktop installation rack mounting connect to ground 4 specification.

  • Page 3: Introduc

    1 introduc tion package contents • gigabit ethernet switch • ac power cord • 4 rubber feet • mounting kit (screws & mounting brackets) main features • complies with ieee 802.3, ieee 802.3u and ieee 802.3ab standards • 10/100/1000 mbps ethernet ports • auto-negotiation ports provide smart switching b...

  • Page 4: Introduc

    2 front panel led status description power on power is on off power is off led/act 1000m on port is connected and operating at speed of 10/100 mbps or 10/100/1000 mbps off port is disconnected blinking data transmitting rear panel power jack: the power jack is used for connecting the switch to the p...

  • Page 5: Safet

    3 safet y instruc tions preparation before installation • keep away from moisture, water or other liquids • keep in a low temperature, low humidity environment • keep away from dust, direct exposure to sunlight, radiators, heat sources and strong electromagnetic fields (ie. Motors) • allow for adequ...

  • Page 6: Inst

    4 inst all ation desktop installation 1. Remove the adhesive backing papers from the rubber feet. 2. Attach the supplied rubber feet to the recessed areas on the bottom of the switch 3. Set the switch on a flat surface strong enough to support the entire weight of the switch. Keep enough ventilation...

  • Page 7: Inst

    5 inst all ation rack mounting 1. First secure the supplied rack-mounting brackets to each side of the switch with the screws (included) 2. After the brackets are attached to the switch, use suitable screws to secure the brackets to the rack (not supplied) note: • make sure that the rack is level an...

  • Page 8: Inst

    6 inst all ation note: • never remove the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection or an authority electrician if you are not sure about what suitable grounding is available. • do not use adapter ...

  • Page 9: Specific

    7 specific ations general standards ieee 802.3, ieee 802.3u, ieee 802.3ab, ieee 802.1x protocol csma/cd data transfer rate ethernet: 10 mbps (half duplex)/20 mbps (full duplex) fast ethernet: 100 mbps (half duplex)/200 mbps (full duplex) giga bit ethernet: 2000 mbps (full duplex) topology star perfo...