Vacmaster VP112 User Manual - page 7
Please read all instructions before operating the VP112.
INSTALLING THE VP112 SEAL BAR
Before using the VP112 for the first time, the seal bar must be installed.
1. Locate the seal bar inside the VP112 box.
2. Open the transparent lid with both hands, using the lid lift handles.
3. At the front of the chamber, locate the two piston rods (labeled “A” in the picture below).
Take the seal bar and align the holes on the bottom of the seal bar (labeled “B” in the
picture below) with the two piston rods.
4. Place the seal bar on the piston
rods, making sure the seal bar
and piston rods are aligned.
Do not push the seal bar down
with force. The seal bar should
rest securely on top of the rods.
5. Once the seal bar is in place,
your VP112 is ready for use.
USING THE VP112 VACUUM PACKAGING MACHINE
1. Select a vacuum chamber pouch
Select the proper size of vacuum chamber pouch for the product that you are packaging. Make
sure that the mouth of the pouch does not exceed the length of the seal bar, and make sure the
entire pouch fits inside of the chamber. Allow 1” to 2” (2.5 cm to 5.1 cm) of extra headspace at
the top of the pouch to ensure a quality, air-tight seal. The VP112 accepts vacuum chamber
pouches up to 12”W x 14”L (30.5 cm x 35.6 cm) in size.
2. Attach the power cord and plug the machine into a grounded electrical outlet
VP112 (110V) - Properly insert the electrical cord into the power outlet on the back of the
machine and then plug the cord into the wall outlet. The LED screen on the control panel will
read “OFF”.
VP112EU (220-240V) – Two types of electrical cords have been included with this machine –
UK and EU versions. Select the appropriate electrical cord and properly insert it into the power
outlet on the back of the machine and then plug the cord into the wall outlet. The LED screen
on the control panel will read “OFF”.
A
A
B
B
7
Operating Instructions