Vacmaster VQ1530SIWDC Manual - 6 7
6 7
G
ENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required for assembly.
WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET,
MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE
WET AND DRY VACUUM CLEANER.
UNPACKING YOUR WET AND DRY VACUUM CLEANER & GENERAL
ASSEMBLY
1. Verify that the power cord is disconnected from the power socket. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all
contents as listed on page 5. (fig.4)
5. With the power head removed, turn the container upside down. Insert the
feet with casters into the slots and apply pressure into place and secure
them with supplied screw. Do not over- tighten screws. (fig.5a)
6. Insert the wheel axle into the base. Insert washer onto the axle followed
by rear wheel and insert washer again. Insert the ‘R’ locking pin into the
hole on the end of the axle to retain the wheel. Snap the hub cap on to
the wheel. Repeat the same steps at the other end of the axle. (fig.5b)
7. Insert the handle into the slots located on the top of the power head and
secure it with the screws provided. Do not over tighten the screw. (fig.6)
8. Your vacuum cleaner comes ready for dry vacuum cleaning with
cartridge filter and pre-filter pre-installed. If cartridge filter is not installed,
refer to page 9 for filter installation. (fig.7 & 8) For further dust filtering fit
the pre-filter into the lower tank by fitting it carefully around the top of the
tank.
9. Optional, for improved dust filtering, fit dust bag flange onto the inlet
stub, taking care not to damage the bag. (fig.9)
10. For wet vacuum cleaning, install the supplied foam filter instead of the
cartridge filter. Do not use a pre-filter or dust bag when wet vacuuming.
(fig.10) See page 10 for filter installation.
11. Place the power head back on the container, and secure into place
using the 2 side latches. (fig.11 & fig.12)
12. Insert the locking end of the hose (marked with an arrow) into the
relevant port of the vacuum cleaner and turn to lock into place. (fig.13)
13. Choose the desired accessories and extension wands and push onto
the suction tube. (fig.14)
S
WITCHING ON/OFF
Connect the mains plug.
Switching on the vacuum cleaner:
Position I switches the vacuum cleaner on.
1
2
3
4
5
a
5
b
9
14
10
6
11
7
12
8
13