Vacmaster VQ1530SIWDC Manual - 8 9
8 9
This wet and dry vacuum cleaner has blowing capabilities. To use the
blower feature follow the instructions listed.
WARNING: ALWAYS WEAR SAFETY GOGGLE BEFORE USING
BLOWER.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT
MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the power socket. (fig.1)
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the locking end of the hose (marked with an arrow) into the
relevant port of the vacuum cleaner and turn to lock into place. (fig.2)
5. Fit the desired extension wand and / or nozzle to the vacuum cleaner
hose. (fig.3)
6. Verify that the switch is in the ‘O’ OFF position before plugging the
power cord into the power socket. (fig.4, fig.5)
7. Before turning on the vacuum cleaner, firmly hold loose end of the hose.
Turn the motor on by flipping the switch to the ‘I’ ON position. (fig.6)
M
AINTENANCE
WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET.
MAKE SURE PLUG IS DISCONNECTED BEFORE CHANGING AND
CLEANING FILTERS.
1. Verify that the power cord is disconnected from the power socket. (fig.1)
2. Disconnect the hose from the vacuum cleaner, turning large end in
counter clockwise direction. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Check the hose, attachments, and power cord to verify that they have
not been damaged.
IMPORTANT! Clean or change the cartridge filter regularly for
best performance.
ALWAYS USE CARTRIDGE FILTER FOR DRY
VACUUMING. If the machine is used without the cartridge filter, the motor
will burn out and the warranty will be voided. Always keep spare filters on-
hand.
NOTICE! The filters included are made of high quality materials designed
to stop small dust particles. The cartridge filter should be used for dry pick-
up only. A dry cartridge filter is necessary to pick up dust. If the cartridge
filter is wet, it will clog quickly and be very difficult to clean. Handle the filter
carefully when removing it for cleaning and replacing it. Check the filters for
tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears, replace it immediately.
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER
SOCKET BEFORE REMOVING THE POWER HEAD FROM CONTAINER.
I
NSTALLING & CLEANING CARTRIDGE FILTERS
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the power socket. (fig.1)
1
2
3
4
1
6
2
3
4
5