Vacmaster VWM510 Operator's Manual - Resetting The Remote Control
12
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig.2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
Resetting The Remote Control
1. Set the power switch to remote control position “ ”. (fig. 1)
2. Press the RESET button on the side of the power head with a pen tip until the indicator lights up. (fig. 2)
3. Within the 15 seconds, press and hold the “ON” or “OFF” button on the remote control. If you didn’t
press and hold the “ON” or “OFF” button within the 15 seconds, it will cancel this resetting. (fig. 3)
4
. When the light blinks 3 times, this means the remote control is programmed.
Changing The Battery – Replace Only With A 23AE 12V Alkaline Battery
1. Take a Phillips screwdriver and remove the screws on the remote control. (fig. 1)
2. Slide back the remote cover so that the white triangle on the remote cover points to the unlock symbol
“
” . (fig. 2 & 3)
3. Remove the remote cover from the handle. (fig. 4)