Vacon 50X User Manual - page 83
vacon 50x parameters
vacon
82
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
EMOP+
EMOP increases speed.
EMOP-
EMOP decreases speed.
PI Enable
Enables PI control.
Ref Switch
Switches speed reference signals.
Cur Lim Dis
Disables Current Limit mode.
CurLimIMax
Set the current limit to Imax
SL Override
Takes control away from the serial link.
Seq 1
Sequencer input 1.
Seq 2
Sequencer input 2.
Seq 3
Sequencer input 3.
Seq Dwell
Sequencer dwell mode (pause).
Seq Advance
Sequencer advance (skip).
FLY Dis
Disable Catch-on-fly operation.
This parameter sets the Motor Overload input polarity. The following data values may be
assigned to this parameter:
Parameter Value
Description
NC Operate
A normally closed (NC) connection allows the unit to operate;
the drive faults when the connection opens.
NO Operate
A normally open (NO) connection allows the unit to operate;
the drive faults when the connection closes.
This allow the MOL digital input to be programmable.
Parameter Value
Description
Preset 1
Preset Speed Input 1 (PS1).
Preset 2
Preset Speed Input 2 (PS2).
Preset 3
Preset Speed Input 3 (PS3).
Coast Stop
Activates a Coast-to-Stop condition.
DC Inject
Begins DC injection braking.
Loc/Rem
Switches from Local to Remote mode.
Alt Ramp
Activates Alternate Ramp.
Fault Reset
Resets a fault.
EMOP+
EMOP increases speed.
EMOP-
EMOP decreases speed.
PI Enable
Enables PI control.
Ref Switch
Switches speed reference signals.
Cur Lim Dis
Disables Current Limit mode.
CurLimIMax
Set the current limit to Imax
SL Override
Takes control away from the serial link.
Seq 1
Sequencer input 1.
Seq 2
Sequencer input 2.
Seq 3
Sequencer input 3.
Seq Dwell
Sequencer dwell mode (pause).
Seq Advance
Sequencer advance (skip).
FLY Dis
Disable Catch-on-fly operation.
726 MOL Polarity
Default: NO Operate
Range: Text string
Level 2
727 MOL Configure
Default = MOL
Range: n/a
Level 2