Vacon DPD00109 Installation Manual - page 6
Keypad Remote Control Options
vacon
7
Step 3. Preparing the Keypad Interface Module (KIM) (XRKPM only)
1. There are two housings supplied with the kit; only one will fit your AC drive properly. Select the keypad
module housing that physically matches the one you removed in
Step 2
.
2. Insert the keypad interface board into the rear of the plastic housing that you selected.
3. Fasten it with the three (3) M2.5 x 6 screws provided, limiting the torque applied to 6 in-lb maximum.
4. Remove the adhesive covering liner from the overlay.
5. Align and adhere the overlay to the front side of the keypad module. Press the part down firmly to ensure
adequate adhesion to the plastic housing.
6. Fasten a cable clamp to the outside of the overlay. (Positioning aids are visible on the surface.)
7. Connect the ribbon cable to the interface board through the opening in the overlay. To provide strain relief,
route the cable through the cable clamp that you just installed.
Figure 3: Preparing the Keypad Interface Module (XRKPM Option)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com