VacuMaid EB-210 SuperGroom II Model Manual - page 7
of
7
3. Turn EB-210 SuperGroom II™ right side up.
Tilt cover forward from back until front snaps free.
4. Carefully insert and lift screwdriver at
each brush support to free brush from
base.
5. Remove belt from motor shaft.
To Replace:
1. Slide on washers and brush supports.
6. Remove broken or worn belt.
7. Slide brush supports off to check and clean
brush support areas. See Brush Assembly-EB-
210 SuperGroom II™ for picture of complete
brush.
Base
Brush Support
Belt
Belt
2. Install new belt in belt groove on the brush
assembly, then over motor shaft as show.
Note: Replacement belt number is EB21010.
Belt
Motor
Belt
6
Brush
Support
BRUSH ASSEMBLY
EB-210 SuperGroom II™:
Brush
Washer
Brush
Support
Belt Groove
Washer
10
13
12
14
15
17
16
18
19
22
20
27
26
21
23
9