VADDIO AutoTrak Owner's manual - page 2
Preliminary Owner’s Manual
AutoTrak Audio Interface, Lanyard and Belt Pack Unit Manual 341-XXXX Page 2 of 8
Compliance Information
FCC Part 15 Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15, Subpart B, of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at
his/her own expense.
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference including interference that may cause
undesired operation of the device.
If the equipment does cause harmful interference to television or radio reception, which can be
determined by turning the equipment on and off, the user is encouraged to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to an electrical outlet on a circuit different from that to which
the receiver is connected
• Consult an experienced radio/TV technician for help
Changes or modifications not expressly approved by Vaddio can affect emission compliance
and could void the user’s authority to operate this equipment.