VADDIO CLEARVIEW HD-20SE Installation And User Manual - page 13
ClearVIEW HD-20
SE
QCCU
S
YSTEM
ClearVIEW HD-20
SE
QCCU
S
YSTEM
,
Document Number 342-0937 Rev C
Page 13 of 28
I
NSTALLATION
B
ASICS
:
The ClearVIEW HD-20
SE
QCCU System with the CONCEAL was designed for installation on a
vertical wall surface with Cat-5 cable connectivity for Video, Power and Control signaling (three
Cat-5 cables are required). Installation is simplified in that no custom 8-Pin mini-din cables or
expensive plenum coax cables are needed and no power outlets are required near the camera
bracket. All cabling is routed to the head-end using Cat-5e cables with standard straight through
RJ-45 connectors (568B termination). “Pass-thru” type RJ-45 connectors should be avoided, like
black cats and broken mirrors, if at all possible.
General Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and check
for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the performance
of the camera. After determining the optimum location of the camera system, route the required three (3) Cat-5e
cables from the camera to the head-end. Mark the Cables: POWER, VIDEO and CONTROL.
The three (3) Cat-5 cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket.
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two lower wall
anchors to correctly fasten the Conceal Wall Mount to the wall.
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to attach
the CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall
anchors/screws provided
Note: Check all Cat-5e cables for continuity in advance of final connection.
Plugging the POWER Cat-5e cable into the wrong RJ-45 may cause damage to
the camera system and void the warranty!
Step 2: System Wiring
Follow the sample wiring diagrams for connecting the Cat-5e cables to the camera and Quick-Connect Universal
CCU Interface. Additional diagrams are available on the Vaddio website.
Connect the camera side as follows:
a) Connect the POWER Cat-5 to the Power RJ-45 on the EZIM CCU Slot Card.
b) Connect the VIDEO Cat-5 to the Video RJ-45 on the EZIM CCU Slot Card.
c) Connect the RS-232 control Cat-5 to the “RS-232 IN” RJ-45 on the top row of connectors on the camera.
Connect the Universal CCU side as follows:
Connect the VIDEO Cat-5 cable to the VIDEO FROM CAMERA RJ-45 jack (yellow) on the CCU.
Connect the RS-232 Cat-5 cable to the RS-232 TO CAMERA RJ-45 (Blue) on the CCU.
Wait to connect the POWER Cat-5 cable until later.
CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 2: Camera aligned and attached to
the CONCEAL Wall Mount Bracket (by
two-(1/4”-20) screws in the bottom of
the mount).