VADDIO WallView Installation And User Manual - page 11
WallVIEW HD-USB SR Camera System
WallVIEW HD-USB SR PTZ Camera System Document Number 342-0465 Rev. A 6 Page 11 of 28
F
IRST
T
IME
S
ET
-
UP WITH THE
C
LEAR
VIEW
HD-USB
PTZ
C
AMERA
The ClearVIEW HD-USB PTZ Camera was designed to be exceptionally easy to use and operate. There is
documentation at the back of the manual for pin-outs. These pin-outs are also available, along with application
TechNotes, from the Vaddio website
www.vaddio.com
.
Getting Started
Step 1: Using the HD Video Select Rotary Switch and Camera Settings Dip Switch on the back of the camera,
set up the camera’s output resolution and functional preferences. There is a label on the bottom of the camera
that identifies the choices.
Table: Switch Setting Label on Bottom of the HD-USB Camera:
Step 2: For USB 2.0 proper operation, set the HD VIDEO SELECT switch to “0” (720p/59.94), “1” (1080i/59.94),
“4” (720p/50) or “5” on the HD-USB Camera. These are the only resolutions that the USB 2.0 and H.264 engines
accept. From these four resolutions, all other USB 2.0 and H.264 resolutions are derived.
For concurrent USB 2.0 and Analog Component (YPbPr), switch settings 0, 1, 4 and 5 are the four
resolutions that can be both digital (USB 2.0 or H.264) and Analog (YPbPr). These resolutions,
720p/59.94, 1080i/59.94, 720p/50 & 1080i/59.94 are the most used resolutions for HD video and are
broadcast standards.
For Analog (YPbPr) output only, all HD VIDEO SELECT switch settings will operate.
For Composite output on the BNC connector, this output is independent from the USB 2.0 resolutions and
the SD settings and are formatted by dip switches 5, 6 and 7.
Step 3: Choose the IR frequency (1, 2 or 3) on the camera for use with the IR Remote Commander. Since only
one USB camera can be plugged into a PC at a time, recommended default is Freq. 1 (dip switches 1 & 2 up).
HD Video
Select Switch
Camera Settings 10-Pos Dip Switches
HD-USB
Rear Panel
IR 1
1 & 2 UP
ON
SD
NTSC
SD
PAL
SD 4:3
6 & 7 UP
SD
LB
IMAGE
FLIP
OFF
ON
ON
DIP SWITCH SETTINGS
8
1
2
3
4
5
6
7
9
10
HD VIDEO AND USB 2.0 SELECT
720p/59.94 - USB
1080i/59.94 - USB
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1080p/59.94
1080p/60
720p/50 - USB
1080i/50 - USB
1080p/50
2
1
5
4
3
7
6
8
10
9
ON
IR 2
ON
IR 3
ON
IR
OUT
OFF
9600
bps
38400
bps
SD
SQ
TEST
BARS
OFF
10
OFF
480i/29.97
1080p/25
1080p/30
576i/25
USE ROTARY SETTINGS 0, 1, 4 & 5 FOR USB 2.0 OUT
④