Vaillant geoTHERM exclusive Operating Manual - page 3
3
Operating Manual geoTHERM exclusive VWS 0020071929_00
1
Notes on this manual
The following information is intended to help you
throughout the entire documentation. Further docu-
ments apply in combination with this operating manual.
We accept no liability for any damage caused by fail-
ure to observe these instructions.
Other applicable documents
For the owner of the system:
Guarantee card
No. 802922
For the heating engineer:
Installation instructions
geoTHERM exclusive
No. 0020051614
Other applicable documents are all manuals that de-
scribe the operation of the heat pump, and the manuals
supplied with the accessories used.
1.2 Document
storage
Store this operating manual and all related documents
in such a way that they are available whenever required.
You can store the documents inside the pillar cover.
If you move out or sell the appliance, pass on the docu-
ments to the buyer.
Fig. 1.1 Removing the pillar cover
General information
Notes on this manual 1
General information
The Vaillant geoTHERM exclusive heat pumps in this
manual are referred to in general as heat pumps and
are available in the following models:
Type name
Article number
VWS 63/2 230V
0010007274
VWS 83/2 230V
0010007275
VWS 103/2 230V
0010007276
Table 0.1 Type designations and article numbers
The heat pumps state-of-the-art appliances
which have been constructed in accordance
with recognised safety regulations.
Conformity with the applicable standards has
been demonstrated.
'DACH' seal of approval
VDE seal and Tested Safety
With the CE mark, we confirm as equipment manufac-
turers that the appliances in the geoTHERM exclusive
range satisfy the requirements of the Directive on Elec-
tromagnetic Compatibility (Council Directive 89/336/
EEC). The appliances meet the basic requirements of
the Low Voltage Directive (Council Directive 73/23/
EEC).
Furthermore, the appliances satisfy the requirements of
EN 14511 (Heat pumps with electrically-driven compres-
sors, heating, specifications for appliances for space
heating and for warming drinking water) as well as EN
378 (safety and environmentally related specifications
for refrigerating systems and heat pumps).
Data badge
An identification plate is attached to the baseplate on
the inside of the geoTHERM exclusive heat pump. The
type designation is located at the top of the front clad-
ding (see also Fig. 4.3, Item 1). In Chapter 7.2 of the Ap-
pendix there is a picture of an identification plate for
the benefit of technically-interested customers, and a
table explaining the symbols shown on it.