- DL manuals
- Vais Technology
- Car Receiver
- iVIC-5D
- Owner's Manual
Vais Technology iVIC-5D Owner's Manual
Summary of iVIC-5D
Page 1
Owner’s manual vais vais t te ec ch hn no ol lo og g y y www.Vaistech.Com • lexus • toyota • copyright (c) 2003-2012 vais technology published august 24, 2012 for 5 generation of toyota/lexus navigation system ic i.
Page 2
Do not disassemble or alter doing so may result in an accident, fire or electric shock. Do not block your view do not mount product or any added audio and/or video equipment where it can block your view through the windshield or your view of dashboard indicators and displays. Do not block the airbag...
Page 3
Vais technology shall not be liable for any special, direct, indirect or consequential damages or damages to persons or property arising out of the use of the product, or for any loss of business or profits, even if vais technology has been advised of the possibility of such damages. Vais technology...
Page 4
Connections 4 connecting ivic used for ivic mode programming power and audio wiring harness service port usb 2.0 host a/v 2 port a/v 1 port / ipod interface (if available) video 3/camera port (if equipped) digital video harness ! This is not firewire port! Do not use this connector for any firewire ...
Page 5
Power and audio wiring harness bluetooth module (if equipped) vgpu heatsink (do not cover it!) allow free airflow digital video harness (must be connected) hdmi cable a/v1 video harness or ipod interface harness usb cable (android device charging only if applicable) usb 2.0 extension cable or ipod i...
Page 6
Connections 6 connecting ivic to ivic digital video connector to factory multi-display unit to factory harness from navigation ecu (if present) digital video harness (included) +12v camera power supply camera power supply ground +12v camera power supply camera power supply ground a/v 2 (audio/video)...
Page 7: Attention
Connections 7 head unit (radio receiver) connection diagram used for most 2006-2009 lexus/toyota vehicles connecting ivic to head unit (for lexus/toyota vehicles) a a factory audio harness (if present) plug into head unit (connector “b”) 12-pin connector lexus gx 470 radio receiver shown. Locate con...
Page 8
Installation we strongly recommend that you install the unit in an easily accessible location, so you can later upgrade the unit or re-program it in case of incorrect programming. Important i 8 ivic-5d programming (mode 1) ivic-5d programming steps: @ properly install ivic-5d unit. @ put the “left” ...
Page 9
! Velcro fasteners are not included ! Vais technology strongly recommends grounding the unit to the car chassis for best results. Note warning ! We strongly recommend to ground ivic to the vehicle’s chassis i ! Mounting unit using velcro fasteners carpet or car chassis “soft” velcro fastener “hard” ...
Page 10
About ivic 10 ivic video graphics mode cd-mp3 emulation mode video graphics mode is used for android phone integration, ios app integration, or hdmi/ analog video input. Cd-mp3 emulation is used for mass storage device integration or for selected ipod/iphone models integration (used for devices whic...
Page 11
Video graphics mode 11 vais technology safety message is displayed for 5 seconds. After 5 seconds you can touch the screen to go to video graphics menu. After 5 more seconds safety message will go off. Touch the screen to get to the ivic side “source menu”. Ivic screen will be displayed when you sta...
Page 12
Video graphics mode 12 “factory backup camera” source activates factory backup camera. Available only if backup camera was previously activated at least once using “reverse gear” after vehicle startup. This functionality may not be available for all vehicle models. Source “setup mode” this message w...
Page 13: Attention
Video graphics mode 13 input alias - choose from the following (audio/video 1, av player, dvd, game console) input source - s video signal type - composite (can not be changed) elect input source for audio/video 2. Can be chosen as - audio/video universal composite source, or . Universal audio/video...
Page 14
Video graphics mode 14 with parking brake not engaged, code request will come up, see screen below. With parking brake engaged, ivic will display selected video source. About “video unlock” function (operable while in motion) in order to unlock video playback while in motion feature you need to ente...
Page 15
Cd-mp3 changer emulation control of ivic player is done through your head unit or the steering wheel controls (explained below). Functionality description head unit: to switch between the unit sources you need to use “disc” or “cd” button on the radio (diagram below assumes factory cd changer is pre...
Page 16
16 track+ track- and select the desired track (maximum number of tracks is 999 for cd-mp3 changer emulation mode). You can fast switch through tracks by repeatedly pressing the [track+] / [track-] button. The track will change after a brief pause when you stop pressing the button. Note: if a playlis...
Page 17
Folder+ folder- and select the desired browsing category playlist, artist or album (). Note: if selected browsing category has playable files/songs in it, ivic will start playing selected category. Otherwise ivic will look for next available category. If no category is available to be selected, ivic...
Page 18
Enable/disable “settings mode”- press the [scan] button 8 times (must be done within 1-2 seconds). You will hear a short beep. The unit will not keep this mode in memory, after vehicle ignition is turned off and back on, unit will return to normal mode. Settings mode activate / deactivate “disc swit...
Page 19
Mp3 (mpeg-1 audio layer 3) is a digital audio encoding format using a form of lossy data compression. “mpeg layer 3 audio coding technology licensed from fraunhofer iis and thomson.” “supply of this product only conveys a license for private, non-commercial use and does not convey a license nor impl...
Page 20
Important i (1) after a delay of five seconds, this product will automatically bypass the automobile manufacturer's on-screen warnings concerning use of the onboard navigation system. These warnings are: ”caution, drive safely and obey traffic rules. Watching this screen while vehicle is in motion c...
Page 21
Mass storage device operation 21 ivic player operational notice i ? For scenario 2 and 3 files and folders will be available in the ivic player in the order they were recorded on the disc, which is not always the same order files are located and displayed on your pc. ? Ivic player will recognize all...
Page 22
You need to know 22 ivic player software updates i please check the website for ivic player software updates. Update file is always named “ivic_upd.Bin” and must be placed in update folder “/multimedialinq/update” on the device's first fat16/fat32 partition. Ivic player will check the update folder ...
Page 23
Mass storage device requirements 23 storage device requirements i ? Unit can recognize up to 4 primary partitions accessible as a separate discs. ? Storage must be formatted as fat16 or fat32 (most flash drives come formatted in fat32 and do not need additional re-formatting). ? You must maintain “f...
Page 24
? Unit can recognize up to 4 primary partitions accessible as separate discs. ? Storage must be formatted as fat16 or fat32 (most flash drives come formatted in fat32 and do not need additional re-formatting).. ? You must maintain “free space” on your usb device necessary for unit operation (approxi...
Page 25
Ivic player will create playlists based on m3u files with “.M3u” extension located in folder “[root]/multimedialinq/m3u/”. Ivic player accepts playlist's file name as playlist's name (up to 41 characters*). Ivic player supports up to 999 playlists (“.M3u files”) and up to 999 media files per playlis...
Page 26
“multimedialinq music folder” song 2 song x song 2 song x song 1 song 2 song x song 1 music playlist 1 playlist 2 playlist 3 multimedialinq root song 1 scenario 2 priority 2 location: “[root]/multimedialinq/music/” ivic player will create playlists based on first-level subfolders in the “multimedial...
Page 27
Dpls cache image m3u cache music playlist 1 playlist 2 playlist 3 playlist 4 update control multimedialinq root ivic player internal data structure i ivic player stores all internal data in the folder “multimedialinq”. If that folder is not present on a playable partition, player will create the fol...
Page 28
28 specifications usb section i usb requirements max. Power consumption file system number of partitions usb 1.1/ usb 2.0 2.1a (ipod/iphone/ipad or usb mass storage) + up to 1a for android charging fat12/16/32 up to 4 primary partitions general i power requirements power consumption mp3 wav flac fre...
Page 29: Warranty
Licensing agreement, disclaimers and limited warranty vais technology, ltd 29 license agreement for u.S.A. (hereinafter referred to as ‘product’) and its related software for most toyota/lexus vehicles 2001-2009; (hereinafter collectiv ely referred to as ‘products’). This is a legal agreement betwee...
Page 30
A copy of the ‘operational warnings and safety instructions’ is to be kept with the vehicle at all times. 3.Disclaimer and limitation of warranties . (a) except as otherwise contained herein, the products and related documentation are provided to you, “as is”. In no event shall vais be liable for an...
Page 31
5. Limited warranty. Vais warrants that the products will be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. Vais’s sole obligation under this warranty is to repair or replace at vais's option, any products that vais shall have determined to be ...
Page 32: The Vais Products.
6. Other provisions: a. Indemnification of vais, its agents and employees . By purchasing, installing and using the products, you, the end- user, agree to indemnify, defend and hold harmless, vais, and it s affiliates, directors, officers, agents and employees from an y liabilities, damage, loss, cl...