Valeo beep & park Instruction Manual - page 6
6
If the problem persists, please follow these steps:
1.
Contact the dealer where you purchased the product.
2.
Replace the product ECU and recheck the system.
3.
7HVWWKHVHQVRUVZLWKFHUWL¿HG(&8
4.
3OXJFHUWL¿HGVHQVRULQWRWKH(&8DQGUHFKHFN
51
Once reverse gear is selected, an obstacle behind the
vehicle is not detected by the system:
1.
&KHFNWKDWUHTXHVWHGKHLJKWRIVHQVRUV¿WWHGRQWKHEXPSHU
IURPWKHÀRRULVUHVSHFWHGEHWZHHQDQGFP
2.
&KHFNWKDWUHTXHVWHGDQJOHRIVHQVRUV¿WWHGRQWKHEXPSHU
is respected. If necessary, use the angle correction rings for
the installation.
3.
Check that requested distance between sensors on the
bumper is respected (
4.
Check that the sensor is not installed upside-down.
5.
Unplug one sensor at a time to identify the cause of the
anomaly.
The display does not power on after installation:
1.
Check that the power supply wire is connected correctly.
2.
Check that the ignition is turned to ACC ON, and that the
reverse gear is selected.
3.
Check that all wire connections are correct.
4.
Check that the display is not damaged.
The display powers on when reverse gear is not selected:
1.
Check that the power wire of ECU is connected to the
reverse light wire.
The system indicates a defective sensor (the buzzer
beeps 3 times):
3
4
5
6
1.
Check whether the sensor surface is clean.
2.
Check whether the sensor wires are plugged in the
ECU properly.
3.
Check whether the sensor wires are damaged or
not.
4.
Check that the sensor is not damaged.
The object position does not correspond to the
correct indicator on the display:
1.
Check that the sensor cables are connected to the
control unit (ECU) in the correct order (markers
ABCD).
2