Valor 530 B-Vent Installation & Operating Instructions Manual

Other manuals for 530 B-Vent: Installation Booklet
Manual is about: heater

Summary of 530 B-Vent

  • Page 1

    4000343/03 please read this manual before installing and operating this heater. This manual should remain with the homeowner. Warning: if the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. What to do...

  • Page 2

    Safety and warning information children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room as the appliance. Do not place furniture or any other...

  • Page 3: Options

    3 options heater engine unit # 530xan/p/xcn/p and b-vent conversion kit #552bvk is used with all installations. The 530 b-vent installation requires the cast iron stove # 531csb—cast stove black. Additional optional features circulating fan kit #555cfk. Having variable speed and temperature control,...

  • Page 4: General

    4 general approvals & codes this appliance is certified by international approval services for use in canada and the usa. The appliance is for installation connected to an approved 4” metal b type vent. This appliance is supplied for use with natural gas. It can be converted for use with lp gas with...

  • Page 5: Supply Gas

    5 supply gas all appliances are supplied for installation with natural gas. The supply pressure must be between the limits shown in section ratings of this manual. The supply connection is 3/8’’npt. The opening for the gas supply line is at the rear left corner of the appliance. Pack contents #552bv...

  • Page 6: Appliance Preparation

    6 appliance preparation detach the window. Refer to the installation instructions supplied with the 530 engine. Check ignition spark. Refer to the installation instructions supplied with the 530 engine. B-vent conversion kit installation remove the rear outlet vent collar and seal by unscrewing 12 s...

  • Page 7

    7 adapting burner module detach the battery shield by removing two screws. Detach the burner module by removing 11 screws. Fit a “p” clip at the right side of the inside of the case. Fit the vent switch wire to the clip. Disconnect the thermocouple from the regu- lator block. 1. . 3. 4. Fit the ther...

  • Page 8: Venting & Appliance Fixing

    8 attaching top air deflector refer to the installation instructions supplied with the 530 engine. Floor fixing refer to the installation instructions supplied with the 530 engine. Venting & appliance fixing refer to the installation instructions supplied with the 530 engine. Gas supply installation...

  • Page 9: Operation Checks

    9 operation checks burner operation refer to the installation instructions supplied with the 530 engine. Aeration adjustment refer to the installation instructions supplied with the 530 engine. Venting a check for correct venting of combustion products must be made before the installed heater is lef...