1. DL manuals
  2. Valor
  3. Stove
  4. 550
  5. Installation Instructions Manual

Valor 550 Installation Instructions Manual

Summary of 550

  • Page 1

    Installation instructions compact gas stove model number 550 before installation ensure that the local distribution conditions (identification of the type of gas and pressure) and the adjustment of the appliance are compatible this is not a “do it yourself” product this appliance must be installed b...

  • Page 2

    2 the lpg appliance is for use with g31 at an inlet pressure of 37mbar. These appliances are for use in the united kingdom (gb) and the republic of ireland (ie) only. List of components main pack cast iron stove containing gas burner unit. 1 spigot 2 ceramic base pieces. Set of 5 coals. 1 pair of ce...

  • Page 3

    3 • the minimum flue diameter is 102mm • a cast iron elbow for use with direct flue connection from valor (valor part no. 0591189) is available. This gives connection to a 102mm flue. (see below for 127mm) • a 102mm to 127mm flue adapter from valor (valor part no. 0591199) is available. • the minimu...

  • Page 4

    4 figure 3 figure 2 figure 4 • there must be a flat area 10mm minimum width outside each side and above the top of the closure plate to enable the sealing tape to be properly secure. Note that the closure plate can be cut if necessary. • this fire can be fitted to a purpose made proprietary class "o...

  • Page 5

    5 figure 6 figure 5 figure 8 figure 7 figure 9 • note: prior to connecting the gas supply it is advisable to blow out the gas supply so that any dirt which may be present in the pipe is cleared and cannot enter the gas valve or pilot burner and so cause a blockage • with the supply connected check t...

  • Page 6

    6 figure 12 figure 11 check full operating sequence if the fire is turned off or the flames go out, wait at least 3 minutes before attempting to relight. A safety device in the control stops the fire being turned back on until it is safe. If the blocked flue safety device has operated then it will n...

  • Page 7

    7 final review & customer briefing • visually inspect the appliance. Clean off any marks incurred during installation. • advise the customer how to operate the appliance. Advise the customer that they should read their owner’s guide before operating the fire and always follow the advice in the secti...