1. DL manuals
  2. Valor
  3. Indoor Fireplace
  4. Legend 739ILN
  5. Installation & Operating Instructions Manual

Valor Legend 739ILN Installation & Operating Instructions Manual

Other manuals for Legend 739ILN: Owner's Manual
Manual is about: DV Gas Insert

Summary of Legend 739ILN

  • Page 1

    L egend 4001839-11 ©2010, miles industries ltd. Direct vent gas insert 739iln (ng) & 739ilp (lpg) installation & operating instructions warning: if the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. ...

  • Page 2: Do Not Put

    We recommend that our gas hearth products be installed and serviced by professionals who are certified in the united states by nfi (national fireplace institute ® ). Thank you ... For purchasing a valor by miles industries. Your new radiant gas heater is a technical appliance that must be installed ...

  • Page 3

    Safety and warning information...................................................................4 specifications ................................................................................................5 overview ..................................................................................

  • Page 4

    Safety and warning information children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room as the appliance. Toddlers, young children and others...

  • Page 5

    X x safety and warning information ratings model ng lpg gas natural propane altitude (ft.)* 0-4,500 feet* input maximum (btu/h) 26,000 24,000 input minimum (btu/h) 6,500 13,000 manifold pressure (in w.C.) 3.6 10.0 minimum supply pressure (in w.C.) 5.0 11.0 maximum supply pressure (in w.C.) 10.0 14.0...

  • Page 6

    Overview this appliance may only be installed in an existing unaltered, functioning solid-fuel burning fireplace with a working flue and constructed of non-combustible material. Do not install into combustible construction. This appliance is not approved for installation with a zero clearance kit. 7...

  • Page 7

    28-5/8” (727 mm) 19-1/2” (495 mm) 12” (305 mm) or 12-5/8” (321 mm) varies with outer trim options 9-3/8” (238 mm) or 10” (254 mm) varies with outer trim options 20” (508 mm) gas inlet gas connection electrical inlet optional outer trim or surround sold separately x y dimensions cavity check that mas...

  • Page 8

    9” (229 mm) a b do not put furniture or objects within 36” (914 mm) of the front of appliance combustible mantel clearances *measure taken from the underside of the mantel to finished hearth or surface that the unit is sitting on. Finishing materials combustible materials: material such as wood, com...

  • Page 9

    3” liners 3” min. Bend radius terminal cap flashing 2 x 3” flex liners—see venting table for length allowed typical vent installation see list of approved venting accessories on page 28 of this manual. Vent location the vent terminal must be located through the roof. This direct vent appliance is de...

  • Page 10

    Installation planning installer—read this first 1. You need to know from the homeowner what accessories (surround, door, etc.) will be installed with this fireplace; 2. Unpack the appliance. 3. Check that you have everything. 4. Clean cavity, chimney, ash dump, and clean-out. 5. Install venting pipe...

  • Page 11

    Unpacking the appliance beware of sharp edges! Wear gloves! 1. Unpack the appliance. 2. Unpack any loose items from around the appliance and check against the pack content list provided in the documentation package. 3. Remove the window and set aside in a safe place to avoid damage—see next page. 4....

  • Page 12

    Appliance preparation window removal the window is held in place by four spring-loaded bolts, two at the top and two at the bottom. 1. To remove the window, turn each bolt a quarter turn to disengage the bolt pin. 2. Gently pull the bottom of the window outward and unhook it from the firebox’s openi...

  • Page 13: Option 2B

    Venting installation important: this appliance’s venting system is room sealed and therefore, does not require room air to be used in the combustion process. 1. Rough-in two 3” diameter vent liners into the existing chimney system from the roof. Be careful not to tear or damage the liners in the pro...

  • Page 14

    Supply pressure test tapping manifold pressure test tapping gas supply installation the gas supply inlet connection is a 3/8” npt female connector and is located on the left hand side of the control valve. Use only new black iron or steel pipes or copper tubing if acceptable—check local codes. Note ...

  • Page 15

    Ceramic bricks installation the following guidelines apply for all brick liners. 1. Inside the firebox, on the top of each side, release the screw of the side brick anchors (one per side) just enough to allow them to rotate. 2. Place the rear panel against the back of the firebox, on the ledge at bo...

  • Page 16

    Both front logs to rest slightly on the edge of the firebox window frame. 5. Identify the right cross log; it has a hole under on of its end and it is the shortest cross log. Place it on the right pin located on the rear log. Rest its other end in the crook of the front right log. 6. Identify the mi...

  • Page 17

    Bottom of window (wider frame) window refitting 1. To refit the window, hook its top part to the firebox’s opening frame. Make sure that the wider part of the window frame is at the bottom. 2. While you hold it, push in and turn the two top spring-loaded bolts a quarter turn to engage their pin. 3. ...

  • Page 18

    Packing contents: 1 wall bracket a 2 screws b 1 screw c 2 wall anchor d 1 spacer e (detach before assembly) 1 wall bracket f switch plate alternative 1 alternative 2 alternative 3 remote control handset wall holder installation the remote control kit for this fireplace comes complete with a wall-mou...

  • Page 19

    Bottom of window (wider frame) read the safety information section on page 4 of this manual. Operating your fireplace for your safety, this appliance is fitted with a flame supervision device which will shut-off the gas supply if, for any reason, the pilot flame goes out. This device incorporates a ...

  • Page 20

    Soot or dust can be brushed from the ceramic logs and firebox walls using a soft brush. Dust can also be removed from the burner using a soft brush after removing the ceramic logs. When cleaning, make sure that no particles are brushed into the slots of the burner. Checks a periodic check of the pil...

  • Page 21

    On off owner’s information manual on/off switch in cases where you want to turn off your fireplace and cannot do it with the remote control handset (misplaced, lost, dead batteries, etc.) or if you need to replace the receiver’s batteries, you can turn off the appliance with the manual switch locate...

  • Page 22

    Remote control operation your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace. The remote controls your fireplace in different ways. Important: before you begin, please note that on this system, the settings of time, temperature and aut...

  • Page 23

    Remote control operation operation modes standby mode—ignited pilot only. Man man mode —manual mode. You can use this mode to adjust the flame height up or down. ☼ temp temp mode —daytime temperature mode (appliance must be in standby mode; pilot ignited): the room temperature is measured and compar...

  • Page 24

    Remote control operation temperature use this setting when you come in and want to enjoy a set temperature. 1. Select either the ☼ temp mode or the ☽ temp mode by briefly pressing the set button. 2. Hold the set button until the temp display flashes. 3. Set the desired temperature with the or the bu...

  • Page 25

    Remote control operation automatic standby mode if there is no transmission from the handset to the receiver within a 6-hour period, the appliance will go to standby (pilot) mode. Handset / receiver match the remote control handset and receiver are programmed to function together. In case of a repla...

  • Page 26

    Lighting instructions warning : if you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Fig 1 fig 2 fig 2a for your safety, read before lighting a. This appliance has a pilot which must be lighted by hand or by remote c...

  • Page 27

    Optional wall switch kit 1265wsk connector red yellow gv60 wiring diagram wiring diagram 27.

  • Page 28

    Venting accessories approved direct vent suppliers for valor models 739 & rf24dv venting parts description venting parts code / availability by manufacturer simpson dura-vent selkirk icc excel direct secure vent rlh industries miles industries termination caps vertical standard co-axial 46dva-vc 4dt...

  • Page 29: Lor

    Warranty 1. Extended warranty coverage for a period of up to ten (10) years, miles industries ltd., (the “company”) or its appointed distributor will at its option pay the initial purchaser for the repair of, or will exchange the following parts or components which are found to be defective in mater...

  • Page 30

    Code description part number 1 exhaust slide assembly 4001133 2 exhaust slide gasket 4000176 3 fan closure plate 4001136 4 port cover 4001820ah 5 log support 4001841 6 side bricks anchors (2) 4001283 7 top mounting bracket 4000136by 8 side mounting brackets (2) 4000135by 9 window assembly 4001378 10...

  • Page 31

    Spare parts ng lpg 18 20 25 21 22 23 24 19 49a 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 44 43 45 62 63 64 65 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 14a ng lpg 13a 31.

  • Page 33

    Thank you ... For purchasing a valor by miles industries. Your new radiant gas heater is a technical appliance that must be installed by a qualified dealer. Please circle where appropriate - ask your installer or your dealer if in doubt. The information provided will be used for customer records onl...

  • Page 34

    Tape shut thank you for choosing a valor product postage needed were you given all documentation and manuals for your product? Yes no miles industries ltd. 190 - 2255 dollarton highway north vancouver, bc v7h 3b1 canada fold here online warranty registration at www.Valorfireplaces.Com.