Valor Portrait 530ICN/ICP Installation & Operating Instructions Manual - page 28
Time
To set the time, follow the steps below.
The display indicates °C/24-hour or °F/12-hour clock. To change from one to the other, press
and hold both the
OFF and buttons until the display changes.
To set the time, hold down
both the and buttons until the display flashes. Let go.
Quickly press the button to set the hour and the button to set the minutes.
Note: You must start setting the time while the display is flashing. If it stops flashing, go back to
.
Press the
OFF button to return to manual mode or simply wait and it will automatically return
to Manual mode.
1.
.
.
.
Temperature
Use this setting when you come in and want to enjoy a set temperature.
Select either the ☼
temp
MODE or the ☽
temp
MODE by briefly pressing the SET button.
Hold the
SET button until the TEMP display flashes.
Set the desired temperature with the
or the buttons.
Note: 4.5°C/40°F is the minimum temperature setting.
Press the
OFF button or simply wait and the display will go to the temperature control mode.
Note: If you would like the Nighttime Setback temperature control to turn off, decrease the
☽
temp
MODE setting until [---] appears on the display.
Your fireplace will reach the set temperatures and the remote handset will check the tempera-
ture every five minutes, adjusting the amount of fuel needed to give you a steady, even heat.
The display must remain in
TEMP mode on the remote handset.
1.
.
.
.
.
Timer
It is possible to program two periods of time per day at which your fireplace will turn on and off
automatically.
For example, you can set your fireplace to turn on in the morning just before you get up (P1
☼
[
start time
])
and to turn off when you leave for the day
(
P1
☽ [stop time]). Then, you can set your
fireplace to turn on again at the end of the day (P2
☼ [
start time
])
and to turn off when you go to
bed at night (P2
☽ [stop time]).
If you wish to set only one time period at which your fireplace will turn on and off, program P2
☼
[
start time
]
and P
☽ [stop time] for the same time as P1 ☽ [stop time].
Select
TIMER mode by briefly pressing the SET button.
Press and hold the
SET button until TIMER is displayed on the lower right hand side.
Press and hold the
SET button until P1☼ and the time display flashes. Set the start time by
pressing the
button for the hour and the button for the minutes. Then, briefly press SET to
P1
☽ and set the stop time in the same manner you just set P1 ☼.
Briefly press the
SET button again for the next burner cycle time, which will be P2
☼ and
P
☽.
Once all four times are set, press
OFF or simply wait to complete programming.
The remote handset must remain in
TIMER mode to function automatically.
1.
.
.
.
.
.
Owner’s Information