Valor RF24XBN Installation And Owner's Manual - page 22
22
Window Refi tting and Checking
Hook the window over the top edge of the fi rebox, and
fasten the bottom two spring loaded bolts by pushing in
and turning 90 degrees.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window, reinstall
it by sliding it between the glass and the frame as
indicated.
Note: To remove the window, the optional bottom
cover or the cast iron fret and fret retainers will
need to be removed fi rst—see sections Optional
Cast Iron Fret Installation or Optional Bottom Cover
Installation.
Spring-loaded
Fastening Studs (2)
1/4 Turn
Remote Control Installation
1. Connect the wiring harness to the receiver box, by pushing the wire connector on to the
receiver circuit board. The plug will only go on one way so please ensure that the wires
are pointing up and slot in the board is in line with the tab on the wiring harness plug.
2. Connect wires as shown. Please note that the “L” connectors are different sizes, the smaller one fi ts to the
lower connection and the larger one the top connection on the top left hand side of the valve. The other two wire
connectors can be fi tted to either terminal located to the left of the fl ame control button.
3. Remove the remote control receiver lid.
4. Fit four AA 1.5 V alkaline batteries.
5. Place the remote control receiver on the base of
the fi replace beside the valve.
6. Fit the 9 V alkaline battery to the handset
transmitter.
Remote control operating instructions are on
pages 8–10 of this manual.
Remote Receiver
Receiver
GV34 Valve
Push-on
Connector
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE CONTROL RECEIVER until the
wires are connected to the burner control unit as short-circuit could result
in the destruction of the electrical components.
CAUTION
DO NOT USE a screwdriver or other metallic object to remove the batteries from the
receiver or the handset! This could cause a short circuit to the receiver.
Hot Glass Plate
QUALIFIED
INSTALLER