Valor RF24XBN Installation And Owner's Manual - page 9
9
OWNER’S
INFORMATION
Remote Control Operation
Setting the temperature
Use this setting when you come in and want to enjoy a specifi c temperature.
1. Push
the
AUTO button until a number and F fl ash. Let go.
2. While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
Setting the fl ame
Use this setting when you want a particular fl ame level. For instance, you want to
watch fl ames burn at their highest level and you don’t mind if the room is too hot.
1. To raise the fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
2. To lower the fl ame, press and hold the ▼ button until the fl ame gets to the
desired level. Let go.
The fl ame level will remain just as you set it.
Programming time and temperature
You can set your fi replace to come on before you wake up and turn off after you leave
and then, turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
1. Decide what temperature you want your fi replace to be at. Also, decide what time
you want your fi replace to turn on and off. Finally, decide what time you want it to
come back on and off in the afternoon or evening. For the fi rst few times you set
the timer, it’s handy to write these times down.
2. Set the temperature (just as you did in the section Setting the temperature.)
3. Press the TIMER button and hold it until P1
☼ appears and flashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn on in the morning.
4. Press the TIMER button and hold it until P1
☽ appears and fl ashes. Let go. While
fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your fi replace to turn off when you leave.
5. Press the TIMER button and hold it until P2
☼
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace will turn back on in the afternoon.
6. Press the TIMER button and hold it until P2
☽ appears and fl ashes. Let go. While
fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your fi replace to turn off in the evening.
7. That is all you have to do. Your fi replace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your fi replace for only one time on and off, set P2
☼
and P2
☽
for the same times as P1
☽. The remote will record the P1 ☽ off time for both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go back to
manual settings. Press TIMER to go back to your settings.