Value Hobby 48in EPP MXS ARF Instrucition Manual - page 13
of
16
www.valuehobby.com/48in-mxs-epp.html
Step4. Use one M2*6mm screws and one to
install the long servo arm to the stock servo
arm.
Install the pushrod connector to the long servo
arm.
Cut off the servo arm on the opposite side.
Step5. Install the servo arm to the servo, and
slide the pushrod through the pushrod
connector.
Step6. With the rudder centered, tighten the
screw of the pushrod connector.
Section6. Landing Gear Installation
Step1. Locate the assembled landing gear and
plywood insert.
Step2. Insert the landing gear into the slot in
the fuselage.
Step3. Apply epoxy to the plywood insert and
insert it to the fuselage.