Value Hobby Aviator-Pro 60 ARF Instruction Manual - Installation
www.valuehobby.com
11
Step10. Once the requirements satisfied in step9,
apply thin CA on both the top and bottom of the
stabilizer to secure the stabilizer onto the fuselage.
(It’s better to use epoxy in this step.)
Section 5: Rudder and Tail Wheel
Installation
Step1. Slide the fin back into the fuselage.
(Note: Check the alignment of the fin to the
stabilizer using a square. The fin must be 90
degrees to the stabilizer when properly aligned. If
not, carefully sand the bottom of the fin to provide
the clearance to align the fin.)
Step2. Apply the epoxy to both the exposed wood
on the fin and the slot in the fuselage. Use carefully
not to get epoxy on the elevator joiner wire.
Slide the fin back into the fuselage, use a square
and tape to hold it in position till the epoxy fully
cures.
Step3. Locate the tail wheel assembly.
Step4. Assemble the tail wheel as shown, and bend
the wire 90 degrees as shown.
Step5. Use a hobby knife to cut a groove for tail
gear wire.
Step6. Drill a hole in the rudder for the tail wheel
wire.