Value Hobby Aviator-Pro 60 ARF Instruction Manual - Installation
Section 1: Aileron Installation
Step1. Locate the aileron hinges from the hardware
pack, and insert the hinges in the slots in the
trailing edge of the wing.
Step2. Saturate each of the hinges with thin CA.
Make sure to glue both the top and bottom.
Step3. Use the hinge to put the aileron in position.
Use a hobby knife to set the gap between the
control surface and the wing. Also check that the
aileron can move freely without rubbing at the
wing tip.
Apply some thin CA again to secure the aileron to
the hinges.
Step4. Flex the aileron up and down several times
to break in the aileron hinges.
Step5. Repeat steps 1 through 4 for the remaining
aileron.
Section 2: Aileron Servo & Control Horn
Installation
Step1. Locate the items shown in the picture below.
(Servos and Y-Harness sold separately).
Step2. Remove the covering over the aileron servo
opening in the bottom of the wing.
Step3. Use a hobby knife to remove the covering
for servo arm slot.