Value Hobby Neptune Seaplane25 Instruction Manual - page 11
www.valuehobby.com/neptune25.html
Step4. In the same procedure install the
control horn onto the rudder.
Step5. Install the servo arm with pushrod
connector to the servo, and install two servos into
the fuselage. (Electronically center the servo
before mounting).
Step6. With control surface centered, tighten
the grub screws.
Section6: Install elevator servo
and linkage (optional)
We offer another installing method for
elevator servo.
Step1. Use a hobby knife to remove the
coverings for inboard servo.
Step2. Install the servo onto the
horizontal stabilizer.
Step3. Connect
pushrod wire Φ1.8x50mm (2.0-
inch)
to control horn.
With pushrod wire aligned
90
degrees to the hinge line and the holes in the
control horn aligned with the hinge line, use two
M2*16mm (0.6-inch) screws and back plate to
install the control horn to the elevator.
11