Value Hobby Stylus Sport 60 Instruction Manual - page 9
www.valuehobby.com/stylus-sport-60.html
- 9 -
Step3. Use two M2*16mm (.6in) Phillips round head
screws and nut plate to install control horn on the
aileron.
Step4. Center the aileron. Use a felt-tipped pen to
mark the pushrod where it crosses the arm servo.
Step5. Bend the pushrod at the mark and cut the
excess wire. Use a keeper to secure the pushrod to
the arm servo.
Step6. Repeat the step 11 to 14 to finish the other
aileron servo installation.
Section 4: Wing Installation
Required parts and hardware:
Wing panels
Wing joiner 1pcs
Wing bolts plate
Philips roundhead screw M4*35mm (1.4in) 2pcs
Washer Φ4 2pcs
Step1. Insert the wing joiner into the left wing panel.
Use a felt-tipped to draw a line on the joiner against
the wing as shown.
Step2. Use a brush to apply some epoxy to one half of
the joiner. Make sure to coat the front, back, top and
bottom of the joiner with epoxy.
Step3. Slide the wing joiner into the wing panel.