ValuePad VP111 Quick Start Manual - On, Off, And Sleep
4
V○
a
luePad VP111 / VP112 Quick Start Guide
1) Reset Button in the pin hole on the back
Just like a computer needs to be rebooted every day to refresh, it is common to press the reset button in the pin
hole on the back for 3 - 5 seconds to restore a tablet when it is stuck during startup. This operation will NOT change
system settings or remove installed apps or personal data.
2) Factory Data Reset
A complete factory reset can solve issues caused by virus, incompatible apps, lagging and freezing in an old system,
unknown setting changes, etc. To do a factory reset, go to “SETTINGS” – “Backup & Reset” in “Personal” section –
“Factory Data Reset”. Warning: This operation WILL remove personal data and apps. Purchased apps from Google
Play Store can be re-installed after logging back into Google account.
3) A completely drained battery?
Another possible reason for the tablet to not come back on is that the battery has been depleted completely. If the
battery is completely drained, you will have to wait from 5 to 60 minutes until the battery has reached a certain
threshold before it can be turned on. Note this is not a quality issue. All rechargeable lithium batteries behave this
way.
4) Connect the tablet to a computer for 12 hours or longer to restore a low level battery
In some cases, when the battery is drained to 10% or lower, you will need to connect it to a computer overnight (>
12 hours) using the included USB cable to restore the battery before using the reset button in the pin hole or
charging it with the wall adapter. Again this is the way lithium batteries are. Search “empty battery tablet won't
start up” for many helpful tips in the millions of results.
ON, OFF, and SLEEP
Turning the ValuePad On
• To turn the ValuePad ON from an Off state, gently hold the power button for 3 to 8 seconds depending on
battery level. To turn the ValuePad on from “Sleep” mode, simply press the power button.
Turning the ValuePad Off
• To turn the ValuePad off completely, you must hold the power button down for about 2 seconds. A menu
will appear. Select “Power Off”. This is important when traveling with the device, or when the tablet is not in
use for extended periods of time, and to save battery.
Sleep
• ”Sleep” mode requires a much shorter boot up time. To put the tablet in sleep mode, simply press the power
button briefly. To turn the ValuePad on from the sleep mode, also briefly press the power button. Note: WiFi,
Bluetooth, movies and games continue to drain battery while in Sleep mode.
• If tablet doesn't come back on after battery drained, connect it to a computer overnight using the USB cable
before charging it with the wall adapter.