Vanco EVMX4016 User Manual - Www.Vanco1.Com
www.vanco1.com
800.626.6445
26
CONNECT AND OPERATE
1.
Connect up to 16 sources such as a Blu-Ray Player, game console, A/V Receiver,
Cable or Satellite Receiver, etc. to the HDMI inputs on the unit. Do not hotplug!
Insert and extract cables carefully with the power SWITCHED OFF. Connecting and
disconnecting while the unit is powered can result in damage to circuitry.
2.
Connect the output UTP ports and/or HDMI output ports, starting with output 1,
to the included display receivers (using well terminated or pre-terminated Cat5e/6
cables no longer than 230 ft)
3.
If utilizing UTP, connect the output HDMI ports of the display receivers to high-
definition displays such as an HDTV or HD projector that use HDMI inputs. Note
that high-speed HDMI cables are recommended for the distances that are required
for each connection.
4.
Plug in IR blasters to the back of the Matrix Selector Switcher unit (IR TX), the
transmitters are labeled IR TX, place in front of the IR receiver of the source, ensure
that each emitter is placed in front of the IR receiver eye. Double-sided adhesive
tape provided.
5.
Plug in IR receivers to the port of the display receiver baluns (IR RX), the receivers
are labeled IR RX, use provided double-sided adhesive tape to stick emitters at each
display at a desired place that will receive a remote signal.
6.
For power, plug in the source first, followed by the Matrix Selector Switcher (power
supply included), followed by each output connected.
7.
Power on each device in the same sequence.
At this point each display connected should display the assigned source (input 1 at default when powered
on initially), scroll through each of the sources on each display to ensure everything is in working order. Use
included IR remote at each display receiver to test switching function between sources and IR function itself.
If a display is having difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to
highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. If the IR
remote function is not responding, check the emitters to ensure they are placed correctly and are plugged into
the correct IR jacks on the Matrix Selector Switcher unit.