Vantage Hearth VI33NRB Washing Machine

Manual is about: Gas fireplace insert

Summary of VI33NRB

  • Page 1

    For more information, visit www.Fmiproducts.Com warning: if the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. — do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or...

  • Page 2: Safety

    Www.Fmiproducts.Com 113195-01n 2 safety table of contents safety .................................................................. 2 local codes......................................................... 5 unpacking............................................................ 5 product identification ...

  • Page 3: Danger: Carbon Monoxide

    Www.Fmiproducts.Com 113195-01n 3 danger: carbon monoxide poisoning may lead to death! Carbon monoxide poisoning: early signs of carbon monoxide poisoning resemble the flu, with headaches, dizziness or nausea. If you have these signs, the fireplace may not be working properly. Get fresh air at once! ...

  • Page 4: Safety

    Www.Fmiproducts.Com 113195-01n 4 safety continued 1. This appliance is only for use with the type of gas indicated on rating plate. This appliance is not convertible for use with other gases. 2. Do not place propane/lp supply tank(s) inside any structure. Locate propane/ lp supply tank(s) outdoors (...

  • Page 5: Local Codes

    Www.Fmiproducts.Com 113195-01n 5 local codes product identification figure 1 - log base assembly figure 2 - fireplace insert top louver assembly firebox hood bottom louver assembly screen assembly firebox support o f f p ilo t o n h i l o three piece log set remote selector switch (optional) piezo i...

  • Page 6: Remote Control Accessories

    Www.Fmiproducts.Com 113195-01n 6 remote control accessories product features there are four optional remote controls that can be purchased separately for this fireplace insert: • wall switch • wall thermostat operation this vent-free fireplace insert is clean burn- ing. It requires no outside ventin...

  • Page 7

    Www.Fmiproducts.Com 113195-01n 7 a. Walls and ceilings exposed to the out- side atmosphere have a continuous water vapor retarder with a rating of one perm (6 x 10 -11 kg per pa-sec-m 2 ) or less with openings gasketed or sealed and b. Weather stripping has been added on openable windows and doors a...

  • Page 8: Warning: If The Area In

    Www.Fmiproducts.Com 113195-01n 8 air for combustion and ventilation continued ventilation air from outdoors provide extra fresh air by using ventilation grills or ducts. You must provide two perma- nent openings: one within 12" of the ceiling and one within 12" of the floor. Connect these items dire...

  • Page 9: Warning: Before Installing

    Www.Fmiproducts.Com 113195-01n 9 warning: before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creo- sote, ashes and loose paint by a qualified chimney cleaner. Note: your vantage hearth fireplace in- sert is designed to be used in zero clearance...

  • Page 10: Caution: Close Masonry

    Www.Fmiproducts.Com 113195-01n 10 installing surround kit (gb38 or gb43) caution: close masonry fireplace damper securely be- fore installing fireplace insert. If chimney does not have a damp- er, block or cap top of chimney. Failure to cap an open chimney could cause drafts that can affect the heat...

  • Page 11: Under Excessive Strain.

    Www.Fmiproducts.Com 113195-01n 11 figure 8 - attaching top surround panel figure 9 - attaching side panels to top panel top surround panel top panel side panel phillips screws (4) top edge of fireplace insert phillips screws 5. Place top surround panel at top of fire- place insert. Bottom edge of pa...

  • Page 12: This Manual.

    Www.Fmiproducts.Com 113195-01n 12 mantel clearances for insert installation if there is a mantel above masonry fireplace, you must meet minimum clearance between mantel shelf and top of fireplace opening (see figure 12). Notice: surface temperatures of adjacent walls and mantels become hot during op...

  • Page 13: Installation

    Www.Fmiproducts.Com 113195-01n 13 installation continued for propane/lp units, installer must supply an external regulator. External regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11" and 14" of water. If you do not reduce incoming gas pressure, heater ...

  • Page 14: Handle Base By Grates.

    Www.Fmiproducts.Com 113195-01n 14 2. Remove screws that attach log base assembly to fireplace insert (see figure 15). Carefully lift up log base assembly and remove from fireplace insert (see figure 15). Caution: do not pick up log base assembly by burners. This could damage burners. Only handle bas...

  • Page 15: Installation

    Www.Fmiproducts.Com 113195-01n 15 installation continued 4. Check all joints of gas supply piping sys- tem. Apply a noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. 5. Correct all leaks at once. 6. Reconnect fireplace insert and equipment shutoff valve to gas supply. Che...

  • Page 16: Installation

    Www.Fmiproducts.Com 113195-01n 16 35" 17 1 / 4 " 26 1 / 4 " figure 20 - rough opening for installing in masonry fireplace 3. Install gas piping to fireplace location. This installation includes an approved flexible gas line (if allowed by local codes) after equipment shutoff valve. Flexible gas line...

  • Page 17: Installation

    Www.Fmiproducts.Com 113195-01n 17 installation continued figure 24 - installing log set (top view) figure 25 - installing screen notches screws for mounting screen burner ports figure 23 - installing log set o f f p ilo t o n h i l o chassis log set crossover log #3 burner front log #2 back log #1 g...

  • Page 18: Installation

    Www.Fmiproducts.Com 113195-01n 18 installation continued optional wireless hand-held remote control accessories (mrc and trc) installing remote receiver unit 1. Disconnect switch wires from control valve. 2. Remove screws attaching switch plate. 3. Remove switch plate (see figure 26). Discard after ...

  • Page 19: A Few Hours.

    Www.Fmiproducts.Com 113195-01n 19 o f f pil ot lo ih auto off on o n figure 28 - control knob and ignitor button location (shown as supplied, no control options) control knob ignitor button flame adjustment knob selector switch notice: during initial operation of new fireplace insert, burning logs w...

  • Page 20: Operation

    Www.Fmiproducts.Com 113195-01n 20 operation continued ignitor electrode pilot burner figure 29 - pilot natural gas ignitor electrode pilot burner propane/lp gas to turn off gas to appliance 1. Turn control knob clockwise to the off position. 2a. Set selector switch in the off position. 2b. If using ...

  • Page 21: Inspecting Burners

    Www.Fmiproducts.Com 113195-01n 21 inspecting burners figure 31 - correct pilot flame pattern pilot burner figure 32 - incorrect pilot flame pattern pilot burner natural gas pilot burner thermocouple pilot burner thermocouple natural gas propane/lp gas propane/lp gas burner flame pattern figure 33 sh...

  • Page 22: Cleaning and Maintenance

    Www.Fmiproducts.Com 113195-01n 22 cleaning and maintenance warning: turn off heater and let cool before cleaning. Caution: you must keep control areas, burner and circu- lating air passageways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a qualified...

  • Page 23: Cleaning and Maintenance

    Www.Fmiproducts.Com 113195-01n 23 cleaning and maintenance continued logs • if you remove logs for cleaning, refer to installing logs, page 17, to properly replace logs. • replace log(s) if broken or chipped (dime-sized or larger). Burner primary air holes air is drawn into burner through holes in f...

  • Page 24: Troubleshooting

    Www.Fmiproducts.Com 113195-01n 24 troubleshooting warning: turn off heater and let cool before servicing. Only a qualified service person should service and repair heater. Caution: never use a wire, needle or similar object to clean ods/pilot. This can damage ods/pilot unit. Note: all troubleshootin...

  • Page 25: Troubleshooting

    Www.Fmiproducts.Com 113195-01n 25 possible cause 1. Control knob not fully pressed in 2. Control knob not pressed in long enough 3. Equipment shutoff valve not fully open 4. Pilot flame not touching thermocouple, which al- lows thermocouple to cool, causing pilot flame to go out. This problem could ...

  • Page 26: Troubleshooting

    Www.Fmiproducts.Com 113195-01n 26 possible cause 1. Not enough air 2. Gas regulator defective 3. Residues from manufac- turing processes and logs curing 1. Not enough combustion/ ventilation air 1. Turning control knob to hi position when burner is cold 2. Air in gas line 3. Air passageways on heate...

  • Page 27: Warning: If You Smell Gas

    Www.Fmiproducts.Com 113195-01n 27 warning: if you smell gas • shut off gas supply. • do not try to light any appliance. • do not touch any electrical switch; do not use any phone in your building. • immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions....

  • Page 28: Parts

    Www.Fmiproducts.Com 113195-01n 28 parts models vi33nrb and vi33prb 17 o f f p ilo t o n h i l o 8 12 26 7 6 4 3 2 5 9 28 14 13 25 15 16 21 11 10 19 20 19 23 24 22 18 1b 1a 1c 27 4 note: items 27 and 28 are for natural gas only.

  • Page 29: Parts

    Www.Fmiproducts.Com 113195-01n 29 parts this list contains replaceable parts used in your fireplace insert. When ordering parts, follow the instructions listed under replacement parts on page 32 of this manual. Key no. Part no. Description qty. 1a 122081-04 back log • • 1 1b 122081-05 front log • • ...

  • Page 30: Parts

    Www.Fmiproducts.Com 113195-01n 30 parts fireplace insert models vi33nrb and vi33prb 11 14 8 8 14 9 3 14 9 9 2 1 7 10 14 12 5 14 13 15 23 4 27 6 17 16 18 19 20 21 22 22 23 14 24 25 14 26.

  • Page 31: Parts

    Www.Fmiproducts.Com 113195-01n 31 parts fireplace insert models vi33nrb and vi33prb this list contains replaceable parts used in your fireplace insert. When ordering parts, follow the instructions listed under replacement parts on page 32 of this manual. Key no. Part no. Description qty. 1 105517-01...

  • Page 32: Specifications

    Www.Fmiproducts.Com 113195-01n 32 specifications vi33prb • rating: 22,000/33,000 btu/hr • gas type: propane/lp gas • ignition: piezo • pressure manifold: 8.0" w.C. • inlet gas pressure (inches of water): max. - 14" w.C., minimum* - 11" w.C. * for input adjustment vi33nrb • rating: 22,000/33,000 btu/...

  • Page 33: Accessories

    Www.Fmiproducts.Com 113195-01n 33 accessories purchase these accessories from your local dealer. If they can not supply these acces- sories, either contact your nearest parts central or call fmi products, llc at 1-866-328-4537 for information. You can also write to the address listed on the back pag...

  • Page 34: Notes

    Www.Fmiproducts.Com 113195-01n 34 _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _______________________________________________...

  • Page 35: Notes

    Www.Fmiproducts.Com 113195-01n 35 _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _______________________________________________...

  • Page 36: Warranty

    113195-01 rev. N 11/10 warranty keep this warranty fmi products, llc limited warranties new products standard warranty: fmi products, llc warrants this new product and any parts thereof to be free from defects in material and workmanship for a period of four (4) years from the date of first purchase...