1 multi-memory internal card reader w/usb2.0 model no.: ugt-cr905 installation guide v1.02.
2 system requirement • microsoft windows xp/vista/7(32/64 bit) • mac os x 10.4+ package content • vantec multi-memory internal card reader w/usb2.0 • 3.5” to 5.25” mounting bracket • installation guide • installation screws bracket installation instructions left right • step 1: contrast above, disti...
3 •step 2: install the screws to card reader; both left and right (refer to above photo) step 3: put the card reader inside the bracket, tighten the screws. Step 4: finish installation of product if in doubt about how to install the device correctly, please contact an expert or a specialist workshop...
4 proceed with caution. Danger to life! Switch off the computer in which the product is to be installed and all connected devices. Disconnect all devices from the mains voltage and pull out the mains ac power cord! Just turning off at the on/off switch is not enough! • open your computer’s housing a...
5 • install the cables so that they do not protrude into any of the computer’s fan, use cable ties, for example. • close the computer enclosure. • connect your computer and monitor to the mains voltage and switch on all devices. • if your computer does not start correctly, switch it off again immedi...
6 warranty: the multi-memory internal card reader w/usb2.0 comes with a 1 year limited warranty. If your unit should become defective within that time frame, please go to http://www.Vantecusa.Com for information on how to receive warranty exchange or repair. Cosmetic defects and missing parts are no...
7 are cosmetic defects, please contact the retailer from which you purchased the unit immediately and ask for a replacement. Contact: vantec thermal technology www.Vantecusa.Com.
