Vantec UGT-CR905 Installation Manual - page 4
4
Proceed with caution. Danger to life!
Switch off the computer in which the product is to be installed and all
connected devices. Disconnect all devices from the mains voltage and
pull out the mains AC power cord!
Just turning off at the on/off switch is
not enough!
• Open your computer’s housing and carefully remove the cover.
• Look for a free 3.5“installation slot and remove the slot cover.
Often there is a metal shielding behind it, which has to be removed first.
With some casings, you have to unscrew this, with others you have to
break it out carefully. Depending on the casing, you may have to
remove the entire front cover first.
• Apart from the slot cover that is already mounted on the slot, the scope
of delivery includes two more front covers in different colors.
Depending on the existing computer housing, the slot cover can easily
be replaced by another one.
• Connect the 9-pin USB plug to an internal USB port on the
motherboard. It is imperative to observe the correct orientation (see
operating instructions for the motherboard) since a wrong connection
may damage both the motherboard and the electronics of the
3.5“plug-in unit, loss of warranty (refer to below photo)!