VAPamore MR-100 PRIMO Instruction Book And Users Manual - page 6
CLEANING / MAINTENANCE
IMPORTANT : When storing the Vapamore, turn the machine off and unplug from
the wall outlet. After the machine has cooled (aprox. 15 min), hold the steam gun trigger
down to release the remaining steam pressure.
CLEANING /STORAGE
Always ensure before cleaning or maintaining the Vapamore MR-100 Primo that it is
switched of and unplugged from the wall outlet. Only clean the outer surface with a
slightly, water moistened cloth. Do not use any cleaning agents, abrasives or alcohol
since they may damage the housing finish.
Fig.24
Lubricate the threads on the water tank cap with light oil or lubricating spray such as
WD-40 once every 3 months or when needed.
R
ACCESSORIES
!
or
The tank should be emptied before storing for any
extended period of time (30 days or more). To empty
the tank, make sure the Vapamore is completely cooled
down, remove the water tank cap and flip the Vapamore
upside down to drain any remaining water from the
tank. Leave the water tank cap off until the water tank
is completely dry. (Fig.24)
GO TO VAPAMORE.COM TO SEE THE MR-100 PRIMO INSTRUCTIONAL VIDEO
The steam gun, extension tubes, and floor cleaning head can be stored (as
shown on the cover page of this instruction manual) by inserting the tab on the floor
cleaning head into the slot located on the side of the Vapamore.
!
Parts, extension tubes and accessories can also be stored in the supplied mesh storage
bag.
Replacement accessories and parts are available to order online at vapamore.com or by
calling Vapamore at 480-951-8900.
STORAGE
The included micro fiber cover and cotton cover can be machine washed using normal
detergents and wash cycle.
PROBLEM?
IMPORTANT :
TROUBLESHOOTING
GO TO VAPAMORE.COM TO SEE THE MR-100 PRIMO INSTRUCTIONAL VIDEO
What do I do if the machine or an accessory becomes damaged or broken?
Visit www.vapamore.com for a complete list of parts and accessories available for
purchase or simply call us at 480-951-8900 or E-mail us at info@vapamore.com to
purchase replacement parts or schedule a repair. WE ARE HERE TO HELP...
TROUBLESHOOTING
One of the ETL protection devices has been triggered or the power cord has been
Call us at 480-951-8900 or E-mail us at info@vapamore.com to schedule a repair.
Do not return to the place of purchase for warranty or repairs. Only
damaged.
The tank could have a build up of lime scale due to the use of hard water.
The tank must be de scaled by using a chemical de scaler . All chemicals must be
removed from the water tank before the machine is operated. Anything other than 100%
pure water inside the tank during operation could cause permanent failure of damage
and can be very unsafe to operate.
Vapamore is authorized to facilitate all repairs to keep the highest quality and ETL
standards. Repairs or tampering by any other party will void the Warranty.