Vaporetto ECO PRO 3000 Manual - page 12
VAPORETTO ECO PRO 3000
23
ENGLISH
CARE OF YOUR VAPORETTO
• Before carrying out any maintenance on the
device, always unplug it from the power mains
making sure that the product has cooled down
before proceeding.
• After using the brushes, we recommend let-
ting the bristles cool down in their natural po-
sition, in order to avoid any deformation.
• To clean the body of the appliance, simply use
a moist cloth.
• Regularly check the status of the coloured
washer located in the connector assembly
(4). If necessary, replace with the appro-
priate spare part (15), as described below.
- Remove the damaged washer.
- Insert the new washer, placing it on the steam
nozzle and pushing it until it is in its place.
See (Fig. B)
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quantities
of vegetable oils.
Make the same check also on the connec-
tion washers of the extension tubes (7)
and of the steam gun (2). If necessary, re-
place with the appropriate spare part (15),
as described below.
- Remove the damaged washer.
- Insert the new washer, placing it on the steam
nozzle and pushing it until it is in its place.
See (Fig. C).
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quantities
of vegetable oils.
OPTIONAL ACCESSORIES
IRON ACCESSORY (Q)
Vaporetto can be quickly transformed into a
highly effective ironing system to make iro-
ning quick and easy. Simply connect the pro-
duct to the iron accessory for Vaporetto.
• mod. PFEU0013 - Professional Iron
• mod. PFEU0031 - Inox Iron
You may purchase the iron accessory at any
Polti service centre or from top home ap-
pliance retailers.
USE OF IRON
Connect the connector assembly at the end of
the iron hose (4) to the generator as shown in
the section “Instructions for Use”.
Before ironing an item of clothing, always check
the symbols on its label, for the instructions pro-
vided by the manufacturer.
Check, based on the following table, the most
appropriate type of ironing:
STEAM IRONING
• For STEAM ironing, turn the dial (S) and set
the iron temperature to its maximum travel on
the “COTTON-LINEN” steam position.
• Wait for a few minutes until the “Iron heating”
indicator light (V) goes out, to show that the
soleplate of the iron has reached the required
temperature.
• Press the steam request button (R) to enable
the steam to come out. The steam flow will
stop when the button is released. After each
filling, when you first start to use the iron, a
few drops of water mixed with the steam may
be emitted (due to imperfect heat stabilisa-
tion). It is therefore advisable to direct the first
jet of steam onto a rag.
• The iron can also be used in a vertical posi-
Fig. B
Fig. C
Steam ironing allowed
For dry ironing, set temperature adjust-
ment knob (S) on •••
Steam ironing allowed
For dry ironing, set temperature adjust-
ment knob (S) on ••
Check the fabric's resistance to steam iro-
ning or dry iron with temperature adjust-
ment knob (S) set on •
- do not iron
- steam ironing or treatment not allowed
VT ECO PRO 3000 - 1U02 PRELIMINARE 2014:VT 2300 M0S05357 1L05
25/02/2014
14.26
Pagina 23