Vari TRIMMER-50 Instructions For Use Manual - page 14
TRIMMER-50
TRIMMER-60
14
Adjust the engine speed at maximum, let the string head run on maximum rotations
and then drive the machine against the stand to be cut. The mown stand will be thrown
onto the right side of the machine (as viewed by the operator). Should the stand be low
and not too dense or lodged, you can proceed by pushing the machine continually and
slowly forward.
In the case that the grass stand is high, dense or lodged, the styl of work will be
different. Drive the machine into the stand, stop it, and cut the stand out by moving the
machine from side to side in oscillations of about 60° (as if mowing with a scythe).
Caution! When cutting, the string head should be at all times slightly above the ground
(2-5 cm). If this rule is not observed, the machine will be forced to sides due to the
contact of the rotating string head with the ground. The phenomenon can be rectified by
adding a guide wheel. Leading the string head low above the ground provides for a good
balance of the machine.
5.6.2 String installation procedure
1) Cut a string length of max. 45 cm
(TRIMMER 50) or 50 cm
(TRIMMER 60) from the coil and
freely bend the string to have two
half-lengths.
Figure 3
2) Pass the string ends through the outer eyes
of the holder
Figure 4
3) Pass the loose ends through the middle
eye of the holder and below the loop.
Figure5
4) Tighten firm by pulling out.
Figure 6
! After having installed a new string, always make sure that the string does not
overlap the cutter by more than 1 cm. If so, cut it by scissors or by knife. The
string will shorten to its precise length after the string head has started rotating.
! Use only the string size and type recommended by the manufacturer of the
machine.