Variquest Awards Maker 400 User Manual - page 13
9
7. Connecting the Printer to the VariQuest™ Design Center 1000
or PC
Important! Use the USB cord that is supplied with your printer to connect to the VariQuest™ Design
Center 1000 or PC. Do not use a parallel or serial cable.
Note: This printer complies with FCC “Rules and Regulations,” Part 15, for Class A Equipment, using
fully shielded six-foot data cables. Use of longer cables or unshielded cables may increase radiated
emissions above the Class A limits. The power supply barrel connector must be inserted into the power
jack on the back of the printer before connecting the communication cables.
8. Troubleshooting
Typically, when there is an error, the Power LED will keep blinking. The printing job and the communi-
cation between the Design Center or PC and printer will stop.
Please check the following in order to understand the nature of the problem:
A. Power and Ready LEDs blink at the same time
B. Power and Ready LEDs blink alternately
Power LED
Ready LED
ON
ON
OFF
OFF
Possible Problems
Solutions
Sticker not feeding
through
Load the sticker media as indicated in “4. Loading the Sticker Media” on page 3.
Sticker not loaded
Load the sticker media.
Sticker jam
Remove the sticker media and load again.
Power LED
Ready LED
ON
OFF
OFF
ON