VarTech Systems VT14B-C1 User Manual - page 7
14” Fast Scan Series User Guide 150-049
-5-
MODE OPERATIONS
In the normal mode of operation, the LED is not flashing.
Disable Keypad
1. Press and release the FUNCTION (upper right) switch. The LED will now be flashing.
2. Simultaneously press the FUNCTION and the VT (upper left) switches. Note that the VT switch is
not labeled. The LED will momentarily be off and then resume flashing.
3. Press and release the FUNCTION (upper right) switch. The LED will not be flashing.
4. To enable the keypad, repeat the above steps.
Factory Default Settings
1. Press and release the FUNCTION (upper right) switch. The LED will now be flashing.
2. Simultaneously press the VT switch and the VERTICAL SIZE + (bottom right) switches. The LED
will momentarily be off and then resume flashing. All stored setups will be deleted except original
factory setups.
3. Press and release the FUNCTION (upper right) switch. The LED will not be flashing.
Display Storage
1. Adjust the display for Brightness, Contrast, Horizontal Position, Horizontal Size, Vertical Position,
Vertical Size. This is done while the LED is not flashing.
2. Press and release the FUNCTION (upper right) switch. The LED will now be flashing.
3. Adjust the display for Keystone and Pincushion.
4. Press the CONTRAST + switch. This will store the display and return the keypad to normal
operation. The LED will not be flashing.