VarTech Systems VT29B-M User Manual - page 10
POWER
1
4
7
0
2
5
8
3
6
9
VOL
VOL
CH.
CH.
REVIEW
MUTE
Color Monitor Hand Held Remote Operation
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
= 1
= 6
1 2 3 4
ON DIP
1 2 3 4
= 7
ON DIP
= 2
1 2 3 4
ON DIP
1 2 3 4
= 8
ON DIP
= 3
= 4
= 9
1 2 3 4
1 2 3 4
ON DIP
ON DIP
ON DIP
ON DIP
1 2 3 4
1 2 3 4
= 0
= 5
1. Set “Address Setting” on dip switches at rear of monitor:
Set Binary Code on both rows of switches
SW 1 CONTROLS FIRST NUMBER, SW 2 CONTROLS SECOND NUMBER
1 = 1, 2 = 2, 3 = 4, 4 = 8; ADD VALUES TO ACHEIVE DESIRED NUMBER
After setting Binary Code, Monitor Power must be cycled to activate.
2. Depress two digit number on remote to correspond to address setting.
3. Depress “REVIEW” button to activate On Screen Display (OSD).
4. Depress “CH
” or “CH
” button to select adjustment function.
5. Depress “ - “ or “ + “ button to adjust monitor.
6. Depress “POWER” button to save adjustments, and disable remote.
NOTE: The “POWER” button must be depressed when the adjustments are
finished and the OSD is off. This can be confirmed by depressing the “REVIEW”
button again, if the OSD returns, the monitor has not been deselected. Depress
“POWER” button again to deselect monitor.
SW1
SW2
ON = 1
OFF = 0
ON = 1
OFF = 0
8