VarTech Systems VTPC150P User Manual - page 7
Panel Mount Procedure
Panel Mounting Procedure:
1- Cut and drill the pan el (refer to the panel m ount drawin g, Fig ure A). Measurements are
provided in inches and millimeters.
Panel Mounting Cutout:
1- If access to the bottom of the enclosure is
not available following installat ion, attach the
power and all necessary cables to the bottom side of the enclosure at this time.
2- Install the enclosure in the prepared cutout.
3- Secure the enclosure using the lock nuts a nd washer s, supplied with the unit, behind the
holes running along the sides an d the top and bottom of the cu tout in the panel. Extra loc k
nuts and washers are provided.
NOTE:
Use #10-32 nuts for mounting.
4- Tighten all mounting hardware to a torque of 24 inch-pounds.
ATTENTION:
Mounting nuts must be tightened to a to
rque of 24 inch-pounds to provide a
proper panel seal and avoid poten tial damage. Vartech Systems assumes no responsibility for
water or c hemical damage to t he monitor or other equipment within the enclosure due to
improper installation.
5- Attach the power, video and sys tem cables to the bottom side of the enclosure if you hav e
not already done so.
Panel Mount Drawing: Detail –A–
15.0 Panel Mount PC
486-0002-01-03
7