Solutions for demanding applications vartech s y s t e m s i n c. 19.0” panel mount pc model vtpc190p / pss user’s guide read these instructions completely before attempting to operate your new panel mount pc.
19.0 panel mount pc 486-0010-01-02 2 revision history date rev no summary page 8/11/08 00 first issue 10/13/08 01 revised panel mounting drawing 6 7/10/09 02 revised detail a, connector view & system spec. 4, 6 & 7.
19.0 panel mount pc 486-0010-01-02 3 safety instructions x read the safety instructions carefully and keep it for use later. X the chassis metalwork of the module must be installed properly to the main earthing termination for class 1 equipment. X care must be exercised in the application of the sys...
19.0 panel mount pc 486-0010-01-02 4 standard technical specifications: standard monitor: size / type 19.0” sxga tft lcd native resolution 1280 x 1024 contrast ratio 800:1 viewing angles horizontal: 178° vertical: 178° pixel pitch 0.294mm brightness (typical) 250 cd/m² response time (typical) 7ms co...
19.0 panel mount pc 486-0010-01-02 5 power & operational specifications: power input 100 - 240 vac 1.5a 50/60 hz 12 - 24 vdc (optional) 6 – 32 vdc without dvd (optional) power consumption 68w temperature operational: -32°f to 140°f 0°c to 60°c storage: -4°f to 149°f -20°c to 65°c humidity operationa...
19.0 panel mount pc 486-0010-01-02 6 panel mount procedure panel mounting procedure: 1- cut and drill the panel (refer to the panel mount drawing, figure a). Measurements are provided in inches and millimeters. Panel mounting cutout: 1- if access to the bottom of the enclosure is not available follo...
19.0 panel mount pc 486-0010-01-02 7 connections to the panel mount pc bottom rear view - connector panel - power connection (power in) the panel mount pc includes an ac line cord which is 6ft long. The power input receptacle is located on the bottom rear panel of the system. Serial connections (com...
19.0 panel mount pc 486-0010-01-02 8 turning the system on and off before connecting the panel mount pc to power, connect any peripheral devices. As a general rule, any peripheral device should only be connected or disconnected when the panel mount pc is off with the exception of any usb or 1394 per...
