Vauxhall VIVARO Quick Reference Manual
Refer to Owner’s Manual for detailed information. Note: some items described may be optional 3.
Quick Reference Guide
Vivaro
Instruments and controls
1. Stalk for lighting and turn signals
2. Driver’s airbag 3 / horn
3. Stalk for Windscreen wiper
and wash
4. Ashtray
Vehicle security
5. Bonnet release lever
6. Park Pilot 3
7. Headlight range adjustment
8. Radio / infotainment controls 3
9. Switches for heated rear windows 3,
central locking and Winter and
Laden programmes for Tecshift 3
10. Hazard warning switch
Unlocking with two function remote or
selective door locking (three function)
remote:
Press button c to unlock on remote
control, within a range of 3 metres 3
- or - turn key in driver’s door lock to
unlock vehicle.
Press button G on the selective door
locking remote to unlock side and rear
loading doors.
Door locking with two function remote
or selective door locking (three
function) remote:
Press button e to lock on remote control,
within a range of 3 metres 3
- or - turn key in driver’s door lock to lock
vehicle.
Press button G on the selective door
locking remote to lock side and rear
loading doors.
Central locking switch:
Locks or unlocks all doors from inside the
vehicle. Press bottom of switch to lock or
top of switch to unlock
Engine immobiliser
z
Deactivated when key is in ignition
z
Activated when key is removed
Engine cannot be started in any other
way so keep spare key in a safe place!
January 2007
TS 1546-B-07
Vehicle features
Starting the engine:
z
Transmission in neutral, depress
clutch, do not accelerate
z With diesel engines, turn key to M
and allow preheating control
indicator D to go out
z
Turn key to D
Manual transmission:
Reverse gear: with vehicle stationary,
pull up collar and move gearshift lever
against resistance to engage reverse
gear.
Tecshift transmission 3:
Transmission display
Shows the mode, programme and
current gear
.
Depress the foot brake, turn on the
ignition. If T is shown in the
transmission display, the foot brake has
not been depressed. When N is
displayed the engine can be started.
If a gear other than N is selected there
will be a short delay whilst the
transmission shifts automatically into
neutral.
Tecshift 3:
N =
Neutral
o =
Centre position
-
=
Shift to lower gear
+
=
Shift to higher gear
A =
Switch between automatic or
manual
mode
R =
Reverse
Move the selector lever to the
appropriate position and release. The
selector lever will return to the centre
position.
The current gear will be displayed in the
transmission display.
Transmission fault
Indicator
W illuminates in transmission
display.
Tecshift automatic drive mode:
When the engine is started, Tecshift is in
automatic mode, “A” is shown in the
transmission display.
To engage 1st gear depress footbrake
and move selector lever toward +.
The vehicle will begin to creep when the
foot brake is released without
accelerating.
Tecshift manual drive mode:
+
shift to higher gear
- shift to lower gear
Move the selector lever to the
appropriate position and release.
The current gear will be displayed in the
transmission display.
Tecshift (continued)
Winter programme V
For starting-off on slippery surfaces:
Press button V - indicator illuminates in
the transmission display, vehicle pulls
away in a suitable gear.
Press button again to switch off.
Laden programme kg
For optimized gear selection when
vehicle has increased payload:
Press button kg - indicator illuminates in
the instrument panel.
Press button again to switch off.