Vax Air3 Pet Plus VRS114 Let's Get Started - Taking Care of Your Machine
TIP
Cleaning the pre-motor filter and shroud
Emptying the dirt container
Press the dirt container
release button, pull to
remove the dirt container.
Hold dirt container over a bin.
Press the dirt release clip,
allowing dirt/debris to fall out.
Wash the filter under
running water (
40’C
max)
Leave to dry for 24 hours
or until fully dry before
placing back in the
vacuum cleaner.
Turn the dirt container
lid anti-clockwise.
Pull the filter tab to
remove the filter.
Lift the shroud from
the dirt container.
Tap the shroud over a bin
to release dirt/debris.
Lift the dirt container
lid to remove.
Tap the filter over a bin to
remove any dirt/debris.
24hr
MAX
40˚C
!
MAX
40˚C
TAP
TA
P
Taking care of your machine
Don’t over fill the dirt container
to avoid blocking the air flow
through the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason
the machine should overheat, the thermostat will automatically turn the machine
off. Switch off and unplug the vacuum cleaner. Check the machine for blockages
and clean the filters . Wash the filters with warm water (40°C max) and leave
for 24 hours or until fully dry before replacing into the machine. Filters require
cleaning at least every 3-6 months (depending on the level of use).
Don’t use your vacuum cleaner without all of the filters in place.