Vax C85-Z1-Be Let's Get Started - Taking Care of Your Machine
Taking care of your machine
Cleaning the pre-motor filter and sponge
Remove dirt container
by pushing down the dirt
container release button and
lifting the dirt container.
Lift the dirt bin lid release
clip. In a hinge like manner
lift dirt bin lid.
Tap the pre-motor filter and
sponge against a bin to remove
any dirt/debris.
TA
P
MAX
40˚C
!
MAX
40˚C
24hr
Lift the pre-motor filter and
sponge to remove from the
dirt container.
Hold dirt container over a bin.
Pull the dirt release clip at the
bottom of the container, the
dirt release door will open
allowing dirt/debris to fall out.
Emptying and cleaning the dirt container
Taking care of your machine
IMPORTANT: Always switch off and unplug the vacuum cleaner from the electrical socket before assembling,
opening or emptying the dirt container, or before connecting/disconnecting the attachments.
Pre-motor filter needs to be cleaned
every time you empty the dirt container. Do not use your vacuum cleaner
without all of the filters in place.
The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat will
automatically turn the unit off.
Separate the sponge and filter
and rinse under water
(Max 40°C).
Leave to dry for 24 hours or until fully
dry before placing back in the machine.
TIP
Don’t over fill the
dirt container to
avoid blocking the
air flow through the
vacuum cleaner.
MAX
40˚C
!
MAX
40˚C
24hr
24hr