Vax C85-Z1-Be Let's Get Started - Getting Started
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
*
To purchase consumables and accessories, please visit
vax.co.uk
Getting started
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters
to fully dry before putting back into the vacuum machine).
• Clean the pre-motor filter every time the dirt container is emptied and replace the post-motor filter every 12 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
Assembling your vacuum cleaner
Press both buttons at the end
of the hose and push hose
into the hose entry point.
Insert the hose grip into the
telescopic extension tube.
Fully unwind the power
cord. A yellow mark on
the cord indicates the
recommended cord length.
Do not exceed the cord
beyond the yellow mark.
Plug into mains and press
the On/Off button to
switch the machine on.
Press the button on the
telescopic extension
tube and adjust to
required length.
Insert the other end of
the telescopic extension
tube into the floorhead.
When unwinding the
power cord always pull
out to the yellow marker
but no further.