Vax DynamoPower U84-DY-Pe User Manual - What To Do If It Goes Wrong
• Check the ‘This pack contains’ panel on the box to make sure
the part is included with your vacuum cleaner.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace
with a British 13amp fuse.
• The motor thermostat may have tripped. If this has happened,
unplug the vacuum cleaner. Remove and empty the dirt container
and check the hose for blockages. Clean the filters and allow the vacuum
cleaner to cool for approximately 1 hour (if you have washed the filters
you will need to wait 24 hours for the filters to fully dry before putting
them back into the vacuum cleaner).
• The brush bar may be clogged, check the brushbar and clear any hair
or debris Go to ‘Let’s talk technical’.
• The belt may be broken, Go to ‘Let’s talk technical’.
• Empty the dirt container and clean filters. Go to ‘Taking care
of your machine’.
• There may be a blockage in the hose. Remove the hose from the vacuum
cleaner, check and clear any blockages. Go to ‘Let’s talk technical’
• The brushbar may not be turning. Go to ‘My brushbar isn’t turning’ below.
• The brushbar height adjuster dial may not be set to the correct setting.
Go to ‘Using your machine’.
• Make sure the hard floor adaptor is attached/unattached dependant
on the floor surface.
• If the accessory/tool will not pick up, check and clear any blockages.
Go to ‘Let’s talk technical’.
Solution
Problem
Caution: Always unplug the steam cleaner before performing maintenance/troubleshooting checks.
What to do if it goes wrong
There is an
accessory missing?
Why does my vacuum
cleaner have no power?
Why won’t the vacuum
cleaner pick up?
My brushbar
isn’t turning?