Vax DynamoPower U84-DY-Pe User Manual - Getting Started
Press the release clip
on the stretch hose, line
up and push the hose
into the handle.
Slide the handle down
into the main body of
the vacuum cleaner.
Assembling your vacuum cleaner
Getting started
*
To purchase consumables and accessories, please visit
vax.co.uk
Before you Begin
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments or removing
and emptying the dirt container.
CAUTION: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat
the thermostat will automatically turn the vacuum cleaner off. If this happens switch the vacuum cleaner off and unplug from
electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner
to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the machine). For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt and debris
and washed every 3 to 6 months (depending on the level of use). If the vacuum cleaner is blocked, switch off and unplug before
removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brushbar height adjuster must
be set to the highest setting.
Line up the stretch hose with hose guides,
push and clip stretch hose into place.