Vax SLIMVAC VX63 User Manual - page 5
Getting to know your machine
Getting started
Assembling your upright slim vacuum cleaner
Line up the connector on
the reach wand with the
Powered Head. Push the
reach wand down onto
the Powered Head until it
clicks into place.
Push the handheld down
onto the reach wand until
it clicks into place.
The vacuum is not free
standing and in between
uses must always be placed
in the wall bracket, or laid
flat on the floor in a suitable
location, so it does not
become a trip hazard or
can be stepped on.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Model Number
VX63
Name
Vax Cordless Blade Pet Pro
Battery voltage
28.8V
Run time
Up to 45 minutes*
Charge time
4 hours
Weight
3.0 kg
Dust bin capacity
0.3L
Technical Specification
Subject to technical change without notice.
Turn off brushbar on hard floors. Images are illustrative only.
To purchase consumables and accessories, please visit
vax.com.au
*Brushbar and Boost off
Before you begin
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the handheld/attachments
or removing and emptying the dirt container.
For best cleaning results, filters require cleaning at least every 3 months and should be replaced every 12 months
depending upon use.
Lithium-Ion battery safety features
• Over charge protection
• Over load protection
• Short circuit protection
• High/low temp protection
• Deep discharge protection
CAUTION: This vacuum cleaner is not free standing. In between uses or when carrying out any maintenance
always lie flat on the floor in a suitable location so it does not become a trip hazard or can be stepped on.
Battery level indicator
Dirt container lid
Dirt container release button
Reach wand
Powered Head/
accessory release clip
Powered Head
Brushbar
Dirt container
Handheld release button
On/Off button
Handle
Boost mode on/off button
Brushbar on/off button
Charging port
Filter cap
Battery level gauge
Battery level indicator
Charger Specification
Battery Specification
Accessories
& Consumables
Charger model no.
ZD24W342060
Input
100-240V ~ 50/60Hz 0.8A Max
Output
34.2V
600mA
Use with Li-ion Battery 32BTBT3V1 ONLY
Type
Lithium-ion rechargeable battery pack
Battery model no.
32BTBT3V1
Voltage
28.8V
Rating
2.0Ah 57.6Wh
Use with E-TEK model ZD24W342060
Charger ONLY
Powerhead Specification
Model no.
FT3V1B1
Wattage
48W
Voltage
28.8V
Powerhead to be used ONLY
with Vax VX63
Filter pack
Model No. VX63F