Vax V-020 PU Instruction manual - page 7
7
Vax Careline
0870 606 1248
usage/ troubleshooting / service / specification
6. Usage
Plug in machine to power supply.
Press the red button to turn on the power.
Press the green button to activate the pump.
On the Fibreflow wash head ensure that the rocker
switch (A) is towards the back of the head to allow water
to flow through the head (Fig.6/1).
In order to help suck up excess water, the rocker switch
(A) can be pushed to the front position on the Fibreflow
was head. This will prevent water flow, allowing excess
water to be removed (Fig.6/2).
In order to wash upholstery, including stairs and soft
furnishings simply detach Fibreflow wash head from
wand and solution tube and replace with upholstery
wash tool as shown (Fig.6/3).
NOTE: Do not store cleaner with solution in
clean water tank or dirty water in dirty water
tank. Mineral deposits and mildew can form which
will affect the performance of the carpet washer.
7. Troubleshooting
WARNING: To reduce risk of personal injury,
unplug carpet washer before servicing.
PROBLEM: The cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution:
Plug in firmly.
Cause:
No electricity in electrical outlet.
Solution:
Check fuse or breaker.
Cause:
On/off switch not turned on.
Solution:
Push on/off switch to ‘on’.
Cause:
Blown fuse/tripped breaker.
Solution:
Reset circuit breaker or replace fuse.
PROBLEM: Cleaner/accessories won’t pick up
Cause:
Accessories not attached correctly.
Solution:
Refer to page 6 for fitting information.
Cause:
The hose is clogged.
Solution:
Remove the hose and tools. Remove the
obstruction.
8. UK Service & Help
Vax Care 0870 6061248
Monday-Friday
8.00am to 6.00pm
Saturday-Sunday
9.00am to 5.00pm
An answerphone is available outside of these hours. Any
queries or concerns about using the Vax, call the Vax
Careline. Calls are charged at the UK national rate.
Please make a note of the serial number and model
number of the carpet cleaner before calling. There are
over 400 approved Vax Service Agents in the UK. For the
nearest Service Agent, please call the Vax Careline.
www.vax.co.uk
9. Technical Specification
Voltage:
220 ~ 240V 50Hz
Wattage:
1300W
Clean water tank volume: 3 litres
Dirty water tank volume: 4.5 litres
Cord length:
7.5m
Weight:
7.7Kg
Subject to change without notice.
!
!
Fig.6/1
A
A
Fig.6/2
Fig.6/3
!
Vax V-020PU User Guide v2.qxd:Vax V-020(PU) User Guide 17/6/08 10:02 Page 7