Vax V-020/V-020TF Instruction manual - 7. Troubleshooting
2.
In order to help suck up excess water, the rocker
switch (A) can be pushed to the front position on
the Fibreflow was head. This will prevent water
flow, allowing excess water to be removed
(Fig.6/2).
Washing and Drying Hard Floors
1.
On the Hydrodry wash head ensure that the
rocker switch (A) is pushed down towards the
back of the head to allow water and solution to
reach the floor (Fig.6/3).
2.
To wash hard floors move the wash head, slowly
and in even motions, over the area to be cleaned.
3.
To suck up excess water and dry hard floors, the
rocker switch (A) can be pushed forward. This
prevents water and solution flow from the Clean
Water Tank.
Washing Upholstery
1.
Detach either wash head from the solution tube
and telescopic tube.
2.
Pull the telescopic tube out of the handle of the
hose.
3.
Attach the upholstery wash tool directly onto the
handle of the hose (Fig.6/4) and wrap the excess
solution tube around as necessary.
NOTE: Do not store cleaner with solution in clean
water tank or dirty water in dirty water tank.
Mineral deposits and mildew can form which will
affect the performance of the carpet washer.
7. Troubleshooting
WARNING: To reduce risk of personal injury,
unplug carpet washer before servicing.
Problem: The cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause:
No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause:
On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause:
Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Problem: Cleaner/accessories
won’t pick up
Cause:
Accessories not attached correctly.
Solution: Refer to page 6 for fitting information.
Cause:
The hose is clogged.
Solution: Remove the hose and tools. Remove the
obstruction.
Usage / Troubleshooting
6
Fig.6/3
A
Fig.6/2
Fig.6/4
V-020(TF) User Guide.qxd 4/9/06 14:43 Page 7