Vax V-021 Instruction Manual

Summary of V-021

  • Page 1

    Vax careline: 0870 6061248 instruction manual please read carefully before using the carpet washer. Always fully extend the mains cable before use. Please retain these instructions for future reference. Www.Vax.Co.Uk upright carpet washer vax model number: v-021 v-021 user guide.Qxd 5/6/06 4:14 pm p...

  • Page 2: 1. Diagram

    Fig.1/2 1. Diagram parts overview 6 2 1 9 11 12 3 7 10 13 14 8 5 2 1. Handle 2. Clean water tank release button 3. Clean water tank 4. Dirty water tank latch 5. Dirty water tank handle 6. Exhaust filter 7. Brushbar 8. Dirty water tank 9. Solution release trigger 10. Power cord tidy 11. Power cord ho...

  • Page 3: 2. Safety Information

    3 safety information/preparing the carpet 2. Safety information for household use only when using the carpet washer, basic safety precautions should always be observed, including the following: 1. Do not leave the carpet washer unattended when plugged in. Unplug it from socket when not in use. 2. To...

  • Page 4

    Assembly 1. Line up mid-section with base unit and slot into place (as shown). 2. Insert handle into mid-section ensuring that the solution trigger is at the back of the machine and the screw hole in the handle is lined up with the screw hole in the mid-section (as shown). 3. Insert and tighten scre...

  • Page 5: 4. Preparing The Carpet

    4. Preparing the carpet important: do not use the carpet washer as a dry vacuum. 1. Vacuum carpet thoroughly. Use a vacuum cleaner with a revolving brushbar for best results. 2. Remove as much furniture from the room as possible. If unable to remove the furniture, place plastic or foil under and aro...

  • Page 6: 6. Usage

    3. Fill remainder of clean water tank with warm (max 40°c) tap water. Replace cap. 4 place bottom of clean water tank into carpet washer and push back until it locks into place. 6. Usage plug cord into electrical socket. Turn on the machine by using the on/off switch located on the side of the machi...

  • Page 7: 7. Troubleshooting

    4 when finished cleaning remove the dirty water tank and rinse with warm water and allow it to dry before storage. Also remove filter (as shown) rinse with warm water and allow it to dry thoroughly before storing. Important: do not use any chemicals when cleaning. Note: do not store cleaner with sol...

  • Page 8

    Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility declare that the product v-021 rapide spring is manufactured in compliance with the following: safety: 73/23/eec low voltage directive, as modified by 93/68/eec emc: 89/336/eec electromagnetic compat...